Difficulty

Difficult

Steps

8

Time Required

                          35 - 45 minutes

Sections

1

  • Power Switch
  • 8 steps

Flags

0

  • BackDrill Master 1500 Watt Dual Temperature Heat Gun

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Power Switch
  • Be sure the heat gun is unplugged before starting this process.
  • Remove the seven 14mm screws from the side of the drill using the PH#0 screwdriver.
  • You will need a screwdriver extension.

Be sure the heat gun is unplugged before starting this process.

Remove the seven 14mm screws from the side of the drill using the PH#0 screwdriver.

You will need a screwdriver extension.

1024

Step 2

  • Remove the 8mm screw from underside of barrel using the PH#0 screwdriver.
  • Don’t try to open the casing just yet.

Remove the 8mm screw from underside of barrel using the PH#0 screwdriver.

Don’t try to open the casing just yet.

Step 3

  • Remove the barrel casing on either end by twisting and pulling each side off.

Remove the barrel casing on either end by twisting and pulling each side off.

Step 4

  • Remove the top casing to reveal inside of drill. You might have to tug a little harder for this one.

Remove the top casing to reveal inside of drill. You might have to tug a little harder for this one.

Step 5

  • Loosen four screws on the wire connector using the flathead 2.5 screwdriver.
  • Screws do not come out of connector.

Loosen four screws on the wire connector using the flathead 2.5 screwdriver.

Screws do not come out of connector.

Step 6

  • Squeeze the tabs on either side of the power switch to remove from the casing.

Squeeze the tabs on either side of the power switch to remove from the casing.

Step 7

  • Remove the black, plastic wire protectors from the end of the power switch.

Remove the black, plastic wire protectors from the end of the power switch.

Step 8

  • Use soldering iron to remove the electrical wiring from the power switch. To replace the power switch, solder the new switch onto the wires.
  • Heating the soldering metal will allow you to pull off the electrical wiring.
  • For a brush-up on proper soldering, check out How to Solder and Desolder Connections.

Use soldering iron to remove the electrical wiring from the power switch. To replace the power switch, solder the new switch onto the wires.

Heating the soldering metal will allow you to pull off the electrical wiring.

For a brush-up on proper soldering, check out How to Solder and Desolder Connections.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 4 other contributors 


                    Mikayla Kim

Member since: 01/31/2017

517 Reputation

                                      5 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       University of North Texas, Team 1-2, Campbell Spring 2017                        

                                                  Member of University of North Texas, Team 1-2, Campbell Spring 2017 



                    UNT-CAMPBELL-S17S1G2                     


                                            3 Members                     


                                            10 Guides authored