Drill Master Heat Gun Power Cord Replacement Repair Guide

Difficulty

Easy

Steps

8

Time Required

                          10 minutes            

Sections

1

• Power Cord
• 8 steps

Flags

0

• BackDrill Master 1500 Watt Dual Temperature Heat Gun

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Power Cord               

• Be sure the heat gun is unplugged before starting this process.
• Remove the seven 14mm screws from the side of the drill using the PH#0 screwdriver.
• You will need a screwdriver extension.

Be sure the heat gun is unplugged before starting this process.

Remove the seven 14mm screws from the side of the drill using the PH#0 screwdriver.

You will need a screwdriver extension.

1024

Step 2

• Remove the 8mm screw from underside of barrel using the PH#0 screwdriver.
• Don’t try to open the casing just yet.

Remove the 8mm screw from underside of barrel using the PH#0 screwdriver.

Don’t try to open the casing just yet.

Step 3

• Remove the barrel casing on either end by twisting and pulling each side off.

Remove the barrel casing on either end by twisting and pulling each side off.

Step 4

• Remove the top casing to reveal inside of drill. You might have to tug a little harder for this one.

Remove the top casing to reveal inside of drill. You might have to tug a little harder for this one.

Step 5

• Loosen four screws on the wire connector using the flathead 2.5 screwdriver.
• Screws do not come out of connector.

Loosen four screws on the wire connector using the flathead 2.5 screwdriver.

Screws do not come out of connector.

Step 6

• Disconnect the power cord wiring from the wire connector.

Disconnect the power cord wiring from the wire connector.

Step 7

• Remove the two 12mm screws from the base of power cord using the PH#0 screwdriver.

Remove the two 12mm screws from the base of power cord using the PH#0 screwdriver.

Step 8

• Remove the power cord from the heat gun.

Remove the power cord from the heat gun.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 

                    Mikayla Kim                     

Member since: 01/31/2017

517 Reputation

                                      5 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges                           

Team

                       University of North Texas, Team 1-2, Campbell Spring 2017                        

                                                  Member of University of North Texas, Team 1-2, Campbell Spring 2017 



                    UNT-CAMPBELL-S17S1G2                     


                                            3 Members                     


                                            10 Guides authored