Difficulty

Moderate

Steps

11

Time Required

Suggest a time??

Sections

1

  • Motor
  • 11 steps

Flags

0

  • BackDrill Master 1500 Watt Dual Temperature Heat Gun

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Motor
  • Be sure the heat gun is unplugged before starting this process.
  • Remove the seven 14mm screws from the side of the drill using the PH#0 screwdriver.
  • You will need a screwdriver extension.

Be sure the heat gun is unplugged before starting this process.

Remove the seven 14mm screws from the side of the drill using the PH#0 screwdriver.

You will need a screwdriver extension.

1024

Step 2

  • Remove the 8mm screw from underside of barrel using the PH#0 screwdriver.
  • Don’t try to open the casing just yet.

Remove the 8mm screw from underside of barrel using the PH#0 screwdriver.

Don’t try to open the casing just yet.

Step 3

  • Remove the barrel casing on either end by twisting and pulling each side off.

Remove the barrel casing on either end by twisting and pulling each side off.

Step 4

  • Remove the top casing to reveal inside of drill. You might have to tug a little harder for this one.

Remove the top casing to reveal inside of drill. You might have to tug a little harder for this one.

Step 5

  • Remove the metal casing and fan cover from the fan unit.

Remove the metal casing and fan cover from the fan unit.

Step 6

  • Bend the metal prongs backward that connect the fan motor to the plastic cap.
  • Bending the brackets too far back can cause the brackets to break.

Bend the metal prongs backward that connect the fan motor to the plastic cap.

Bending the brackets too far back can cause the brackets to break.

Step 7

  • Remove the plastic cap from the motor,
  • This will allow you to work only with the motor and fan.

Remove the plastic cap from the motor,

This will allow you to work only with the motor and fan.

Step 8

  • Remove the fan by pulling it from the motor rod.

Remove the fan by pulling it from the motor rod.

Step 9

  • Remove the two 12mm screws from the plastic fan casing using PH#00

Remove the two 12mm screws from the plastic fan casing using PH#00

Step 10

  • Remove the plastic fan casing.

Remove the plastic fan casing.

Step 11

  • Remove the metal casing from the motor and insert the new motor in its place.
  • You may have to tug a little.

Remove the metal casing from the motor and insert the new motor in its place.

You may have to tug a little.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 4 other contributors 


                    Mikayla Kim

Member since: 01/31/2017

517 Reputation

                                      5 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       University of North Texas, Team 1-2, Campbell Spring 2017                        

                                                  Member of University of North Texas, Team 1-2, Campbell Spring 2017 



                    UNT-CAMPBELL-S17S1G2                     


                                            3 Members                     


                                            10 Guides authored

jstabler38 - Oct 30, 2017

Reply

Where can I find a new motor?