Difficulty
Moderate
Steps
8
Time Required
15 - 30 minutes
Sections
1
- Fan
- 8 steps
Flags
0
BackDrill Master 1500 Watt Dual Temperature Heat Gun
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Fan
- Be sure the heat gun is unplugged before starting this process.
- Remove the seven 14mm screws from the side of the drill using the PH#0 screwdriver.
- You will need a screwdriver extension.
Be sure the heat gun is unplugged before starting this process.
Remove the seven 14mm screws from the side of the drill using the PH#0 screwdriver.
You will need a screwdriver extension.
1024
Step 2
- Remove the 8mm screw from underside of barrel using the PH#0 screwdriver.
- Don’t try to open the casing just yet.
Remove the 8mm screw from underside of barrel using the PH#0 screwdriver.
Don’t try to open the casing just yet.
Step 3
- Remove the barrel casing on either end by twisting and pulling each side off.
Remove the barrel casing on either end by twisting and pulling each side off.
Step 4
- Remove the top casing to reveal inside of drill. You might have to tug a little harder for this one.
Remove the top casing to reveal inside of drill. You might have to tug a little harder for this one.
Step 5
- Remove the metal casing and fan cover from the fan unit.
Remove the metal casing and fan cover from the fan unit.
Step 6
- Bend the metal prongs backward that connect the fan motor to the plastic cap.
- Bending the brackets too far back can cause the brackets to break.
Bend the metal prongs backward that connect the fan motor to the plastic cap.
Bending the brackets too far back can cause the brackets to break.
Step 7
- Remove the plastic cap from the motor,
- This will allow you to work only with the motor and fan.
Remove the plastic cap from the motor,
This will allow you to work only with the motor and fan.
Step 8
- Remove the fan by pulling it from the motor rod and replace.
Remove the fan by pulling it from the motor rod and replace.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 4 other contributors
Mikayla Kim
Member since: 01/31/2017
517 Reputation
5 Guides authored
Badges:
6
+3 more badges
Team
University of North Texas, Team 1-2, Campbell Spring 2017
Member of University of North Texas, Team 1-2, Campbell Spring 2017
UNT-CAMPBELL-S17S1G2
3 Members
10 Guides authored
