Dremel Multipro 395 Casing Replacement Repair Guide

Difficulty

Moderate

Steps

9

Time Required

Suggest a time??

Sections

1

• Casing
• 9 steps

Flags

0

• BackDremel MultiPro 395

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Casing               

• Remove the blue caps located on either side of the MultiPro, using a 3 mm flathead screwdriver.

Remove the blue caps located on either side of the MultiPro, using a 3 mm flathead screwdriver.

1024

Step 2

• Carefully remove the carbon brushes attached at the end of the springs by gently pulling on the springs using your hands.

Carefully remove the carbon brushes attached at the end of the springs by gently pulling on the springs using your hands.

Step 3

• Pull one side of the hanger up and then pull away from the Multipro until the other side can be pulled out.

Pull one side of the hanger up and then pull away from the Multipro until the other side can be pulled out.

Step 4

• Remove the 4 screws located on the bottom of the Multipro with a T15 screwdriver.

Remove the 4 screws located on the bottom of the Multipro with a T15 screwdriver.

Step 5

• Hold down the collet lock, remove the chuck cap from the top of the Multipro by screwing counterclockwise.

Hold down the collet lock, remove the chuck cap from the top of the Multipro by screwing counterclockwise.

Step 6

• Remove the black housing cap from the Multipro located directly below the chuck cap.

Remove the black housing cap from the Multipro located directly below the chuck cap.

Step 7

• Pull the bottom side of the casing up to remove it.

Pull the bottom side of the casing up to remove it.

Step 8

• Gently lift the motor shaft out of the Multipro.

Gently lift the motor shaft out of the Multipro.

Step 9

• Pull the lock pin and its casing out of the other side of the Multipro case.

Pull the lock pin and its casing out of the other side of the Multipro case.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.                                             

Author

                                      with 3 other contributors 

                    Matthew Satton                     

Member since: 09/17/2014

490 Reputation

                                      2 Guides authored                  



                       Badges:
                       15







                                                        +12 more badges                           

Team

                       University of Kentucky Louisville, Team 1-5, Mathis Fall 2014                        

                                                  Member of University of Kentucky Louisville, Team 1-5, Mathis Fall 2014 



                    LOUISVILLE-MATHIS-F14S1G5                     


                                            5 Members                     


                                            4 Guides authored                     

bari - Nov 21, 2017

Reply

A link to parts is always nice,