Difficulty
Easy
Steps
6
Time Required
5 - 10 minutes
Sections
2
- Prerequisite Guide to Accessing Interior
- 3 steps
- Mother Board
- 3 steps
Flags
0
BackdreamGEAR Quad Dock Pro
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Prerequisite Guide to Accessing Interior
- Remove the rubber foot pads on the bottom of the device using a plastic opening tool.
Remove the rubber foot pads on the bottom of the device using a plastic opening tool.
1024
Step 2
- Remove the six 2 mm PH0 screws on the bottom of the device.
- Four of those screws are located under the foot pads.
Remove the six 2 mm PH0 screws on the bottom of the device.
Four of those screws are located under the foot pads.
Step 3
- Gently remove the bottom of the device.
Gently remove the bottom of the device.
Step 4
Mother Board
- Remove the four 1.8 mm J1 screws.
- Remove the two 2mm PH0 screws.
Remove the four 1.8 mm J1 screws.
Remove the two 2mm PH0 screws.
Step 5
- Gently pick up the mother board
- Pick the mother board straight up or you may risk damaging the mini-USB charging ports.
Gently pick up the mother board
Pick the mother board straight up or you may risk damaging the mini-USB charging ports.
Step 6
- Use a plastic opening tool or similar tool to gently pry the power ribbon cord out of its port.
Use a plastic opening tool or similar tool to gently pry the power ribbon cord out of its port.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 4 other contributors
Jacob
Member since: 03/11/2015
750 Reputation
6 Guides authored
Badges:
13
+10 more badges
Team
Colorado Springs, Team 4-4, Panko Spring 2015
Member of Colorado Springs, Team 4-4, Panko Spring 2015
UCCS-PANKO-S15S4G4
3 Members
6 Guides authored
