Difficulty

Difficult

Steps

7

Time Required

                          15 - 20 minutes

Sections

3

  • Prerequisite Guide to Accessing Interior
  • 3 steps
  • Mother Board
  • 3 steps
  • Electrical Port
  • 1 step

Flags

0

  • BackdreamGEAR Quad Dock Pro

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Prerequisite Guide to Accessing Interior
  • Remove the rubber foot pads on the bottom of the device using a plastic opening tool.

Remove the rubber foot pads on the bottom of the device using a plastic opening tool.

1024

Step 2

  • Remove the six 2 mm PH0 screws on the bottom of the device.
  • Four of those screws are located under the foot pads.

Remove the six 2 mm PH0 screws on the bottom of the device.

Four of those screws are located under the foot pads.

Step 3

  • Gently remove the bottom of the device.

Gently remove the bottom of the device.

Step 4

              Mother Board
  • Remove the four 1.8 mm J1 screws.
  • Remove the two 2mm PH0 screws.

Remove the four 1.8 mm J1 screws.

Remove the two 2mm PH0 screws.

Step 5

  • Gently pick up the mother board
  • Pick the mother board straight up or you may risk damaging the mini-USB charging ports.

Gently pick up the mother board

Pick the mother board straight up or you may risk damaging the mini-USB charging ports.

Step 6

  • Use a plastic opening tool or similar tool to gently pry the power ribbon cord out of its port.

Use a plastic opening tool or similar tool to gently pry the power ribbon cord out of its port.

Step 7

              Electrical Port
  • Locate the three solder connections for the electrical port.
  • Desolder the connection points following the instructions included with your soldering kit as you remove the port.
  • FIRE HAZARD! BURN DANGER! Follow all the safety precautions included with your soldering kit.
  • It is helpful to use a nylon or metal spudger or tweezers for the removal of this component, pieces of which are very hot.
  • You can follow iFixit’s guide to soldering here.

Locate the three solder connections for the electrical port.

Desolder the connection points following the instructions included with your soldering kit as you remove the port.

FIRE HAZARD! BURN DANGER! Follow all the safety precautions included with your soldering kit.

It is helpful to use a nylon or metal spudger or tweezers for the removal of this component, pieces of which are very hot.

You can follow iFixit’s guide to soldering here.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 3 other contributors 


                    Jacob

Member since: 03/11/2015

750 Reputation

                                      6 Guides authored                  



                       Badges:
                       13







                                                        +10 more badges

Team

                       Colorado Springs, Team 4-4, Panko Spring 2015                        

                                                  Member of Colorado Springs, Team 4-4, Panko Spring 2015 



                    UCCS-PANKO-S15S4G4                     


                                            3 Members                     


                                            6 Guides authored