Difficulty
Easy
Steps
3
Time Required
2 minutes
Sections
2
- Dreamer Autoshade Driver Tube Disassembly
- 2 steps
- Motor Set Screw
- 1 step
Flags
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
Better Introduction
Improve this guide by completing or revising its introduction.
BackDreamer Autoshade
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Step 1
Remove motor hub fasteners
- Remove the four Phillips head screws that fasten the motor hub to the tube adapter.
Remove the four Phillips head screws that fasten the motor hub to the tube adapter.
1024
Step 2
Remove driver bearing cap
- Using a flathead screwdriver, pry the bearing cap from the tube.
Using a flathead screwdriver, pry the bearing cap from the tube.
Step 3
Tighten Motor Set Screw
- Move the hub to the edge of the shaft so it is flush, and tighten the set screw using a T5 screwdriver bit.
- The hub should fit snugly on the shaft, unable to rotate freely.
- Optional- Add a drop of thread locking liquid to permanently hold the set screw in place after tightening.
Move the hub to the edge of the shaft so it is flush, and tighten the set screw using a T5 screwdriver bit.
The hub should fit snugly on the shaft, unable to rotate freely.
Optional- Add a drop of thread locking liquid to permanently hold the set screw in place after tightening.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 1 other contributor
David
Member since: 11/11/2020
734 Reputation
8 Guides authored
Badges:
5
+2 more badges