Dreamer Autoshade Driver Blocking Repair Guide

Difficulty

Easy

Steps

5

Time Required

                          2 minutes            

Sections

2

• Dreamer Autoshade Driver Tube Disassembly
• 2 steps
• Driver Blocking
• 3 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

Better Introduction

Improve this guide by completing or revising its introduction.

• BackDreamer Autoshade

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

What you need

Step 1

              Remove motor hub fasteners               

• Remove the four Phillips head screws that fasten the motor hub to the tube adapter.

Remove the four Phillips head screws that fasten the motor hub to the tube adapter.

1024

Step 2

              Remove driver bearing cap               

• Using a flathead screwdriver, pry the bearing cap from the tube.

Using a flathead screwdriver, pry the bearing cap from the tube.

Step 3

              Loosen PCB mounting Screws               

• Use a #1 Phillips head screwdriver to loosen the PCB mounting screws until the circuit board can be adjusted. This should only take 1-2 full rotations of the screwdriver. Do not fully remove the screws.

Use a #1 Phillips head screwdriver to loosen the PCB mounting screws until the circuit board can be adjusted. This should only take 1-2 full rotations of the screwdriver. Do not fully remove the screws.

Step 4

              Straighten PCB               

• The circuit board can cause problems if it is not properly centered on the sheet metal mount. See the picture for details.
• The blue lines in the picture show the edges of the white metal PCB plate, while the red lines show the edge of the PCB. Adjust the PCB so it lines up as closely as possible with the metal plate. This will ensure that the PCB does not contact the edge of the tube while rotating.

The circuit board can cause problems if it is not properly centered on the sheet metal mount. See the picture for details.

The blue lines in the picture show the edges of the white metal PCB plate, while the red lines show the edge of the PCB. Adjust the PCB so it lines up as closely as possible with the metal plate. This will ensure that the PCB does not contact the edge of the tube while rotating.

Step 5

              Tighten PCB mounting screws               

• Tighten the two PCB mounting screws until the PCB cannot move freely.

Tighten the two PCB mounting screws until the PCB cannot move freely.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 

                    David                     

Member since: 11/11/2020

734 Reputation

                                      8 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges