Dragon Touch M10X Power Volume Button Replacement Repair Guide

Difficulty

Moderate

Steps

5

Time Required

Suggest a time??

Sections

1

• Power/Volume Button
• 5 steps

Flags

Missed a Step

Oops! This guide is currently missing some important steps.

• BackDragon Touch M10X

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Power/Volume Button               

• Remove the two screws from the top of the tablet as shown in the figure using a J0 philips head bit.

Remove the two screws from the top of the tablet as shown in the figure using a J0 philips head bit.

1024

Step 2

• Use the large plastic opening tool to separate the back cover from the device. Wedge the sharp end of the tool into the crack and use leverage to further separate the back cover from the device.
• Still holding pressure on the opening tool, slowly and carefully slide the tool along the gap to separate it further. You should hear slight snapping as it comes apart. Work your way around all sides until the cover is able to be removed.

Use the large plastic opening tool to separate the back cover from the device. Wedge the sharp end of the tool into the crack and use leverage to further separate the back cover from the device.

Still holding pressure on the opening tool, slowly and carefully slide the tool along the gap to separate it further. You should hear slight snapping as it comes apart. Work your way around all sides until the cover is able to be removed.

Step 3

• Ensure your buttons look like this
• If either the buttons or the button holes in the back cover are dirty, clean them.
• If the buttons are cracked or broken, they will have to be replaced

Ensure your buttons look like this

If either the buttons or the button holes in the back cover are dirty, clean them.

If the buttons are cracked or broken, they will have to be replaced

Step 4

• With the old buttons removed place the new ones in

With the old buttons removed place the new ones in

Step 5

• These buttons are held in by gravity alone so when reattaching the device back on to the cover, keep it upside down.
• Secure the bottom of the device first before closing up the sides.

These buttons are held in by gravity alone so when reattaching the device back on to the cover, keep it upside down.

Secure the bottom of the device first before closing up the sides.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.                                             

Author

                                      with 2 other contributors 

                    Eric Megna                     

Member since: 03/24/2016

327 Reputation

                                      2 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges                           

Team

                       UMass Dartmouth, Team 4-7, Catania Spring 2016                        

                                                  Member of UMass Dartmouth, Team 4-7, Catania Spring 2016 



                    UMASSD-CATANIA-S16S4G7                     


                                            3 Members                     


                                            8 Guides authored