Dragon Touch M10X Camera Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          25 - 35 minutes

Sections

Camera
8 steps

Flags

BackDragon Touch M10X
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Camera

Remove the two screws from the top of the tablet as shown in the figure using a J0 philips head bit.

Remove the two screws from the top of the tablet as shown in the figure using a J0 philips head bit.

1024

Step 2

Use the large plastic opening tool to separate the back cover from the device. Wedge the sharp end of the tool into the crack and use leverage to further separate the back cover from the device.
Still holding pressure on the opening tool, slowly and carefully slide the tool along the gap to separate it further. You should hear slight snapping as it comes apart. Work your way around all sides until the cover is able to be removed.

Use the large plastic opening tool to separate the back cover from the device. Wedge the sharp end of the tool into the crack and use leverage to further separate the back cover from the device.

Still holding pressure on the opening tool, slowly and carefully slide the tool along the gap to separate it further. You should hear slight snapping as it comes apart. Work your way around all sides until the cover is able to be removed.

Step 3

Using your hands and the separating tool, remove the back cover from the device.

Using your hands and the separating tool, remove the back cover from the device.

Step 4

Using a J0 phillips head bit, remove the single 1 mm screw from the rear facing lens cover.

Using a J0 phillips head bit, remove the single 1 mm screw from the rear facing lens cover.

Step 5

Using a J0 phillips head bit, remove the single 1mm screw from the front facing camera lens cover.

Using a J0 phillips head bit, remove the single 1mm screw from the front facing camera lens cover.

Step 6

Using a plastic opening tool, pry the rear facing camera out of its housing.

Using a plastic opening tool, pry the rear facing camera out of its housing.

Step 7

Using a plastic opening tool, lift up the latch that attaches the camera’s ribbon cable to the device.
Using tweezers, pull out the ribbon cable from underneath the latch.

Using a plastic opening tool, lift up the latch that attaches the camera’s ribbon cable to the device.

Using tweezers, pull out the ribbon cable from underneath the latch.

Step 8

Remove the camera strip from the device.

Remove the camera strip from the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 3 other contributors

                    Joseph Rockcliffe

Member since: 03/24/2016

573 Reputation

                                      2 Guides authored                  



                       Badges:
                       17







                                                        +14 more badges

Team

                       UMass Dartmouth, Team 4-7, Catania Spring 2016                        

                                                  Member of UMass Dartmouth, Team 4-7, Catania Spring 2016 



                    UMASSD-CATANIA-S16S4G7                     


                                            3 Members                     


                                            8 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team