Dragon Touch A1X Plus Cameras Replacement Repair Guide

Difficulty

Difficult

Steps

10

Time Required

                          30 - 40 minutes            

Sections

2

• Battery
• 6 steps
• Cameras
• 4 steps

Flags

0

• BackDragon Touch A1X Plus

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Battery               

• Insert the plastic opening tool between the white back cover and black front over.

Insert the plastic opening tool between the white back cover and black front over.

1024

Step 2

• Slide the plastic opening tool along the edgeof the device until back cover is detached and remove the cover.
• You may need to pry the back cover off using the opening tool while moving it along the edge.

Slide the plastic opening tool along the edgeof the device until back cover is detached and remove the cover.

You may need to pry the back cover off using the opening tool while moving it along the edge.

Step 3

• Remove the yellow tape holding the battery to the device using your fingers or plastic opening tool if necessary.

Remove the yellow tape holding the battery to the device using your fingers or plastic opening tool if necessary.

Step 4

• Use the hair dryer to melt the glue holding the battery to the device.
• Be careful not to overheat the battery as it could cause the battery to combust.

Use the hair dryer to melt the glue holding the battery to the device.

Be careful not to overheat the battery as it could cause the battery to combust.

Step 5

• Insert the plastic card under the battery and use it to remove the battery from the device.
• Be careful not to deform the battery.

Insert the plastic card under the battery and use it to remove the battery from the device.

Be careful not to deform the battery.

Step 6

• Desolder the red and black wires connecting the battery to the motherboard and remove the battery.

Desolder the red and black wires connecting the battery to the motherboard and remove the battery.

Step 7

              Cameras               

• Remove black tape holding the cameras to the motherboard.

Remove black tape holding the cameras to the motherboard.

Step 8

• Use your fingernail to flip up the small locking flap on the ZIF connector.
• Pull the ribbon cable from the ZIF connector.

Use your fingernail to flip up the small locking flap on the ZIF connector.

Pull the ribbon cable from the ZIF connector.

Step 9

• Remove the front camera from the device using your fingers.

Remove the front camera from the device using your fingers.

Step 10

• Melt the glue holding the rear camera in place using a hair dryer.
• Insert the metal spludger under the rear camera and pry it free from the device.

Melt the glue holding the rear camera in place using a hair dryer.

Insert the metal spludger under the rear camera and pry it free from the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 

                    Josh Null                     

Member since: 03/21/2018

313 Reputation

                                      3 Guides authored                  



                       Badges:
                       3

Team

                       IUPUI, Team S5-G5, Baechle Spring 2018                        

                                                  Member of IUPUI, Team S5-G5, Baechle Spring 2018 



                    IUPUI-BAECHLE-S18S5G5                     


                                            3 Members                     


                                            6 Guides authored