Difficulty
Easy
Steps
6
Time Required
10 minutes
Sections
1
- Case
- 6 steps
Flags
0
BackBeats Pill XL
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Case
- Using a plastic opening tool, pry the casing from the rest of the device.
- Pry all the way around the edge and then pull apart.
- It should be relatively easy, to pull apart. Don’t be afraid to apply a necessary force.
Using a plastic opening tool, pry the casing from the rest of the device.
Pry all the way around the edge and then pull apart.
It should be relatively easy, to pull apart. Don’t be afraid to apply a necessary force.
1024
Step 2
- Using your thumb, remove the 8 rubber plugs in order to get to the screws.
- Simply rub them towards the speakers and they will slide out enough to grip the edge and pull them out.
- In the picture provided, we labeled four of them on one side of the Beats Pill XL. The other four are symmetrical to these four on the other side of the device.
Using your thumb, remove the 8 rubber plugs in order to get to the screws.
Simply rub them towards the speakers and they will slide out enough to grip the edge and pull them out.
In the picture provided, we labeled four of them on one side of the Beats Pill XL. The other four are symmetrical to these four on the other side of the device.
Step 3
- Using a Phillips #2 screwdriver, remove the 8 (10mm maxi-loc Phillips #2) screws that hold the casing together.
Using a Phillips #2 screwdriver, remove the 8 (10mm maxi-loc Phillips #2) screws that hold the casing together.
Step 4
- Pull apart the front casing from the back casing, slowly. Try to avoid any tension on any of the connected cables.
- Separate at a slow constant force to avoid damage to the ribbon cables.
Pull apart the front casing from the back casing, slowly. Try to avoid any tension on any of the connected cables.
Separate at a slow constant force to avoid damage to the ribbon cables.
Step 5
- Gently pull on the plastic tab at the base of the ribbon cable to remove it from the motherboard.
- Never pull the cables by the cord, as this could cause damage to the cables and/or motherboard. Always disconnect the cables from the base by the motherboard.
Gently pull on the plastic tab at the base of the ribbon cable to remove it from the motherboard.
Never pull the cables by the cord, as this could cause damage to the cables and/or motherboard. Always disconnect the cables from the base by the motherboard.
Step 6
- Using your thumb and index finger, pull upwards on the base of the the power cable to remove it from the motherboard.
- Even though there are two batteries, there is only one cable connecting the two to the motherboard.
Using your thumb and index finger, pull upwards on the base of the the power cable to remove it from the motherboard.
Even though there are two batteries, there is only one cable connecting the two to the motherboard.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
4 other people completed this guide.
Author
with 3 other contributors
Nolan
Member since: 03/11/2015
828 Reputation
2 Guides authored
Badges:
13
+10 more badges
Team
Colorado Springs, Team 9-2, Panko Spring 2015
Member of Colorado Springs, Team 9-2, Panko Spring 2015
UCCS-PANKO-S15S9G2
3 Members
7 Guides authored
