Door Stop Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          10 - 15 minutes

Sections

Door Stop
10 steps

Flags

BackDoor And Window
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

You will find the necessary components of the door stop (including screws) in a door stop package.

What you need

Step 1

              Door Stop

Twist the anchor fitting of the old door stop in counter clockwise direction.
Remove the anchor fitting from the mount.
Anchor fitting: is a part of the door stop circled in red.

Twist the anchor fitting of the old door stop in counter clockwise direction.

Remove the anchor fitting from the mount.

Anchor fitting: is a part of the door stop circled in red.

1024

Step 2

Use a drill (or a screwdriver) to remove the two screws from the mount base.
After you remove the mount base, use the hammer to reposition these two screws.

Use a drill (or a screwdriver) to remove the two screws from the mount base.

After you remove the mount base, use the hammer to reposition these two screws.

Step 3

Use a screwdriver to remove the mount base out of the new anchor fitting by spinning the screwdriver counter-clockwise.

Use a screwdriver to remove the mount base out of the new anchor fitting by spinning the screwdriver counter-clockwise.

Step 4

Using a screwdriver or a drill, attach the new mount base to the wall with the two screws.

Using a screwdriver or a drill, attach the new mount base to the wall with the two screws.

Step 5

Attach the anchor fitting into the mount base by rotating it clockwise.

Attach the anchor fitting into the mount base by rotating it clockwise.

Step 6

Remove the old door fitting by rotating it counter-clockwise.

Remove the old door fitting by rotating it counter-clockwise.

Step 7

Use the drill to remove the two screws out of the threaded insert.
Clean the screws holes (if necessary) before putting a new screw in.

Use the drill to remove the two screws out of the threaded insert.

Clean the screws holes (if necessary) before putting a new screw in.

Step 8

Insert a screwdriver into the bottom hole of the threaded insert and rotate it counter-clockwise to remove the threaded insert.

Insert a screwdriver into the bottom hole of the threaded insert and rotate it counter-clockwise to remove the threaded insert.

Step 9

Place the threaded insert onto the door.
Using a screwdriver or a drill, attach the threaded insert to the door with two screws.

Place the threaded insert onto the door.

Using a screwdriver or a drill, attach the threaded insert to the door with two screws.

Step 10

Assemble the rest of the door stop in the following order:
Spring.
Rectangular compartment.
Door stop button.
Outer shell.
Place the door stopper onto the threaded insert and and attach it by rotating it clockwise.

Assemble the rest of the door stop in the following order:

Spring.

Rectangular compartment.

Door stop button.

Outer shell.

Place the door stopper onto the threaded insert and and attach it by rotating it clockwise.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors

                    Khoa Bui

Member since: 09/20/2020

198 Reputation

                                      1 Guide authored                  



                       Badges:
                       3

Team

                       York University, Team S1-G111, Woodhouse Fall 2020                        

                                                  Member of York University, Team S1-G111, Woodhouse Fall 2020 



                    YORK-WOODHOUSE-F20S1G111                     


                                            1 Member                     


                                            1 Guide authored

Introduction#

What you need#

Team#

Introduction

What you need

Team