Difficulty

Easy

Steps

4

Time Required

                          1 hour

Sections

1

  • Grille
  • 4 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackTor für das Babybett Sniglar von Ikea

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Step 1

              Grille
  • Unscrew one of the grilles and saw it apart. On the photo you can see how mine looks in the end. I had decided to make the gate 6 bars wide.

Unscrew one of the grilles and saw it apart. On the photo you can see how mine looks in the end. I had decided to make the gate 6 bars wide.

1024

Step 2

  • Organize a bolt about 6 cm long. I took a screw and sawed off the thick end.
  • Drill a hole in each of the two upper horizontal edges/boards. For me it is 3 cm each. Drill as centrally and horizontally as possible, or minimally upwards.
  • Insert the bolt and push the two grille parts together.

Organize a bolt about 6 cm long. I took a screw and sawed off the thick end.

Drill a hole in each of the two upper horizontal edges/boards. For me it is 3 cm each. Drill as centrally and horizontally as possible, or minimally upwards.

Insert the bolt and push the two grille parts together.

Step 3

  • Screw the assembled grille back onto the bed. Screw in only 3 screws; I left out the screw at the bottom right.
  • Screw on the lower edge which should not be able to be opened with another screw. (This is only possible with pre-drilling).

Screw the assembled grille back onto the bed. Screw in only 3 screws; I left out the screw at the bottom right.

Screw on the lower edge which should not be able to be opened with another screw. (This is only possible with pre-drilling).

Step 4

  • At the bottom of the short side, place another screw in the edge (again with predrilling) so that the bottom cannot fall out.

At the bottom of the short side, place another screw in the edge (again with predrilling) so that the bottom cannot fall out.

Done. Maybe you could think of something else so that the gate stays up when you press against it. However, you can turn the gate 270° and put it on top to get a permanent opening.

Cancel: I did not complete this guide.

        Gegu is helping us fix the world!      Want to contribute?      Start translating ›

Special thanks to these translators:

100%

Gegu

Author

                                      with 1 other contributor 


                    Albertere Zweitausend

Member since: 08/11/2018

400 Reputation

                                      3 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges