Difficulty

Moderate

Steps

7

Time Required

Suggest a time??

Sections

1

  • LCD Display
  • 7 steps

Flags

2

In Progress

This guide is a work in progress. Reload periodically to see the latest changes!

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackDMC-GF3

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              LCD Display
  • Remove the battery and memory card from the device.

Remove the battery and memory card from the device.

1024

Step 2

  • Remove 4 (2mm) screws from the bottom of the unit.

Remove 4 (2mm) screws from the bottom of the unit.

Step 3

  • Remove 4 (4mm) screws from the sides of the unit. You are removing screws from both the right and left sides of the unit (4 screws total)

Remove 4 (4mm) screws from the sides of the unit. You are removing screws from both the right and left sides of the unit (4 screws total)

Step 4

  • Slightly lift up the left side of unit to remove the side panel. Do not remove the rear chassis. Just lift up enough to remove side panel.
  • Caution. The rear Chassis is attached to two ribbon panels so please do not remove the chassis in this step.

Slightly lift up the left side of unit to remove the side panel. Do not remove the rear chassis. Just lift up enough to remove side panel.

Caution. The rear Chassis is attached to two ribbon panels so please do not remove the chassis in this step.

Step 5

  • When opening the rear casing be careful not to pull on the flex cables. There are 2 flex cables on each side of the rear casing.
  • Slightly lift the rear casing. Do not completely remove it. Just lift just enough so the right flex clamp is visible. Keep in mind the left side of the rear casing is also attached to a flex clamp. Use a spudger or other method to release the cable. Do not remove the rear casing yet.

When opening the rear casing be careful not to pull on the flex cables. There are 2 flex cables on each side of the rear casing.

Slightly lift the rear casing. Do not completely remove it. Just lift just enough so the right flex clamp is visible. Keep in mind the left side of the rear casing is also attached to a flex clamp. Use a spudger or other method to release the cable. Do not remove the rear casing yet.

Step 6

  • Remove flex cable using a spudger or other method. Remove rear casing.
  • These plastic clamps are fragile and break easily. Use caution when releasing the cable. Use equal pressure throughout entire clamp or risk breaking the clamp.

Remove flex cable using a spudger or other method. Remove rear casing.

These plastic clamps are fragile and break easily. Use caution when releasing the cable. Use equal pressure throughout entire clamp or risk breaking the clamp.

Step 7

  • Insert wisdom here.

Insert wisdom here.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 2 other contributors 


                    Sales Cameraparts4you

Member since: 07/01/2016

3,042 Reputation

                                      20 Guides authored                  



                       Badges:
                       17







                                                        +14 more badges