Dji Spark Internal Gps Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          5 - 10 minutes

Sections

Propellers
2 steps
Battery
1 step
Lid
2 steps
GPS
3 steps

Flags

BackDJI Spark
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Propellers

Push down on the propeller that is being replaced.

Push down on the propeller that is being replaced.

1024

Step 2

Twist the propeller until it feels loose.
Pull on it until it comes off.

Twist the propeller until it feels loose.

Pull on it until it comes off.

Step 3

              Battery

Flip the drone over.
Grip the left and right sides of the battery.
Slide firmly forward until it pops out.

Flip the drone over.

Grip the left and right sides of the battery.

Slide firmly forward until it pops out.

Step 4

Lid

Flip the drone over.
Remove the four 1.5mm Hex screws.
Remove the two 1.5mm Hex screws near the camera head.
You may need to remove plastic nubs from the hex screws using a spudger first.

Remove the four 1.5mm Hex screws.

Remove the two 1.5mm Hex screws near the camera head.

You may need to remove plastic nubs from the hex screws using a spudger first.

Step 5

Hold the drone so the lid is facing up.
Insert the plastic opening tool into the side of the drone.
Slide the tool around the perimeter until you can lift the top off.

Hold the drone so the lid is facing up.

Insert the plastic opening tool into the side of the drone.

Slide the tool around the perimeter until you can lift the top off.

Step 6

GPS

Identify the GPS module on the motherboard.
The GPS module will be labeled as ‘DJI G116’.

Identify the GPS module on the motherboard.

The GPS module will be labeled as ‘DJI G116’.

Step 7

Remove the four 6.0 mm Phillips #000 screws holding the GPS module to the motherboard.

Remove the four 6.0 mm Phillips #000 screws holding the GPS module to the motherboard.

Step 8

Pick up the GPS module.
Carefully disconnect the GPS module ribbon cable from the motherboard.
Remove the GPS module.

Pick up the GPS module.

Carefully disconnect the GPS module ribbon cable from the motherboard.

Remove the GPS module.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 2 other contributors

                    Amelia Hagberg

Member since: 10/21/2019

403 Reputation

                                      3 Guides authored                  



                       Badges:
                       7





                                                        +4 more badges

Team

                       UMass Dartmouth, Team S1-G7, Botvin Fall 2019                        

                                                  Member of UMass Dartmouth, Team S1-G7, Botvin Fall 2019 



                    UMASSD-BOTVIN-F19S1G7                     


                                            3 Members                     


                                            7 Guides authored

Mark Ryan Fontelar - Apr 11, 2022

How About Spark’s Wifi can’t find?

manzoorsp67 - Oct 16, 2022

GPS module ribbon cable is broken where can i buy?

manzoorsp67 - Oct 16, 2022

please if some one have it send it to me

i will pay u

Introduction#

What you need#

Team#

Introduction

What you need

Team