Dji Phantom 4 Advanced Remote Controller Back Buttons Replacement Repair Guide

Difficulty

Moderate

Steps

7

Time Required

                          10 - 15 minutes            

Sections

2

• Back Panel
• 5 steps
• Back Buttons
• 2 steps

Flags

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

Better Introduction

Improve this guide by completing or revising its introduction.

• BackDJI Phantom 4 Advanced Remote Controller

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

What you need

Step 1

              Back Panel               

• Remove the four screws with a Torx T8 screwdriver to access the back con board.

Remove the four screws with a Torx T8 screwdriver to access the back con board.

1024

Step 2

• Remove three screws using a Phillips #00 screwdriver.

Remove three screws using a Phillips #00 screwdriver.

Step 3

• With tweezers, gently remove the large con board tab.
• Use your hands to remove the two small clips. Pull out from the socket, in a horizontal direction.

With tweezers, gently remove the large con board tab.

Use your hands to remove the two small clips. Pull out from the socket, in a horizontal direction.

Step 4

• Peel off the rubber grips to access the screw holes.
• Make sure to save your grips and do not to get them stuck to anything, you are going to want to save the adhesive.
• Remove the back board and set it aside.

Peel off the rubber grips to access the screw holes.

Make sure to save your grips and do not to get them stuck to anything, you are going to want to save the adhesive.

Remove the back board and set it aside.

Step 5

• Pull apart the back plastic panel.
• Recommended tool for this would be the metal spudger, but not required.
• Once the back panel is off, you will have access to the motherboard.

Pull apart the back plastic panel.

Recommended tool for this would be the metal spudger, but not required.

Once the back panel is off, you will have access to the motherboard.

Step 6

              Back Buttons               

• Using a Phillips #00 screwdriver, remove the four screws on the inside of the panel. That will allow you to remove the buttons by gently lifting them with your hands.

Using a Phillips #00 screwdriver, remove the four screws on the inside of the panel. That will allow you to remove the buttons by gently lifting them with your hands.

Step 7

• Remove back buttons and replace with new ones.

Remove back buttons and replace with new ones.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 

                    Angel Cortez                     

Member since: 10/02/2018

234 Reputation

                                      2 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges                           

Team

                       Linn Benton Community College, Team S1-G4, Johnson Fall 2018                        

                                                  Member of Linn Benton Community College, Team S1-G4, Johnson Fall 2018 



                    LBCC-JOHNSON-F18S1G4                     


                                            3 Members                     


                                            12 Guides authored