Dji Phantom 3 Advanced Landing Gear Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          5 minutes

Sections

Battery
2 steps
Landing Gear
4 steps

Flags

BackDJI Phantom 3 Advanced
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Battery

With the battery facing you, locate the two tabs on the top and bottom of the battery as shown.
Remember to disarm and power down your quadcopter before beginning any disassembly.

With the battery facing you, locate the two tabs on the top and bottom of the battery as shown.

Remember to disarm and power down your quadcopter before beginning any disassembly.

1024

Step 2

Press the two tabs with your finger and thumb, and gently slide the battery towards you, out of the quadcopter frame.
With your other hand, be sure to hold the quadcopter steady to ensure that it stays still.

Press the two tabs with your finger and thumb, and gently slide the battery towards you, out of the quadcopter frame.

With your other hand, be sure to hold the quadcopter steady to ensure that it stays still.

Step 3

              Landing Gear

Turn the phantom upside down.
Remove the eight 7.5mm long 3mm screws, securing the landing gear to the body of the quadcopter, with a T-8 screwdriver.

Turn the phantom upside down.

Remove the eight 7.5mm long 3mm screws, securing the landing gear to the body of the quadcopter, with a T-8 screwdriver.

Step 4

Remove the rubber spacer in the landing gear by pushing the spacer out of the slot with your finger.

Remove the rubber spacer in the landing gear by pushing the spacer out of the slot with your finger.

Step 5

Using a plastic opening tool, carefully separate the two pieces of plastic of the landing gear.
Be careful not to break the wire attached, as this is your receiver antenna.

Using a plastic opening tool, carefully separate the two pieces of plastic of the landing gear.

Be careful not to break the wire attached, as this is your receiver antenna.

Step 6

Feed the wire and attached plastic through the hole in the landing gear.

Feed the wire and attached plastic through the hole in the landing gear.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      6 other people completed this guide.

Author

                                      with 3 other contributors

                    Quinn Tirpak

Member since: 10/06/2016

286 Reputation

                                      2 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       Cal Poly, Team 10-2, Livingston Fall 2016                        

                                                  Member of Cal Poly, Team 10-2, Livingston Fall 2016 



                    CPSU-LIVINGSTON-F16S10G2                     


                                            3 Members                     


                                            12 Guides authored

Art - Aug 17, 2017

I have a single coax cable in my landing gear. the gear broke and the wire tore off the connector. How do I fix this?

Introduction#

What you need#

Team#

Introduction

What you need

Team