Difficulty

Moderate

Steps

0

Time Required

                          1 - 2 hours

Sections

Flags

2

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

Needs Transcription

This guide is in video form only. Help make it more accessible by transcribing each action of the procedure into a separate step and adding photos.

  • BackDJI Mini 3 Pro

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

After replacing the gimbal camera, you may need to calibrate your drone, but this cannot be done using the DJI Fly mobile app, you will need to use additional software. How to calibrate the gimbal watch this video tutorial https://youtu.be/mu03HWXplM4

What you need

Video Instructions

To reassemble your device, follow these instructions.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 1 other contributor 


                    Arty

Member since: 10/27/2019

13,670 Reputation

                                      85 Guides authored                  



                       Badges:
                       20





                                                        +17 more badges

Andre Purdy - Oct 4, 2022

Reply

Does anyone have a source for replacing the little rubber gimbal mounts?

gbonilla - Oct 5, 2022

Reply

HI there! Does anyone know where I can buy the whole gimbal in USA? I remember seeing it somewhere but cannot find it

Arty - Oct 6, 2022

Go to YouTube and check the link to the gimbal assembly in the description below the video

Limon Khan - Dec 10, 2022

Reply

mini 3 pro com port not show on device manegar any help.

Dorin - 4 days agoJan 20, 2023

Reply

Start trembling during flight after a horizontal stop. At the start, I can hear the gimbal noise from trembling (before taking off). I gently touch it, and it stops. I take off and fly a long distance.

If I stop it or it stops it by signal loss, the trembling starts again. if I never stop it and take gentle curves back, it may work. At abrupt stops, it starts trembling. I bring the drone back to me at 1-meter height. I gently touch the gimbal (without landing), and it stops. Then I fly again (if the battery is low, I land, change the battery, and start again, same steps, every time). I will probably buy a new one, so I can send this to repairs - did not check the guarantee yet.

  • no problems during climbing up.- only on horizontal movements and hard stops (release the lever on the controller). I will try never to release the lever abruptly and never lose signal (a signal lost could be a hard brake, also)??? Calibration can stop this strange error ????

1024