Dji Mini 2 Drone Body Replacement Repair Guide

Difficulty

Moderate

Steps

7

Time Required

                          15 - 20 minutes            

Sections

2

• Battery
• 2 steps
• Drone Body
• 5 steps

Flags

0

• BackDJI Mini 2

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

The drone body stores the inner electronic parts of the drone like the GPS, the Main Board, and the wires the drone uses. Damage to the drone body can cause the drone to be unstable in flight. If the body of the drone is damaged they will need to be replaced.

What you need

Step 1

              Battery               

• Face the DJI Mini 2 away from you so that you are looking at the charging ports.
• Use your finger to open up the back panel.

Face the DJI Mini 2 away from you so that you are looking at the charging ports.

Use your finger to open up the back panel.

1024

Step 2

• Pinch the locking mechanism on the battery to release the lock.
• Pull the battery straight out of the compartment.

Pinch the locking mechanism on the battery to release the lock.

Pull the battery straight out of the compartment.

Step 3

              Drone Body               

• Unfold the wings of the drone.
• Place the drone upside down on a flat surface.
• There should be stickers on the device telling you how to unfold the propeller arms.

Unfold the wings of the drone.

Place the drone upside down on a flat surface.

There should be stickers on the device telling you how to unfold the propeller arms.

Step 4

• Remove the four 5 mm J000 screws near each propeller arm.

Remove the four 5 mm J000 screws near each propeller arm.

Step 5

• Flip the drone back over.
• Use a combination of the opening tool and your fingers to pry open the top panel of the drone along the seams.

Flip the drone back over.

Use a combination of the opening tool and your fingers to pry open the top panel of the drone along the seams.

Step 6

• Remove the two 5 mm J000 screws located in the battery hatch and near the ports on the back of the drone.

Remove the two 5 mm J000 screws located in the battery hatch and near the ports on the back of the drone.

Step 7

• Flip the drone over again.
• Pry off the bottom panel of the drone using the opening tools and your fingers.

Flip the drone over again.

Pry off the bottom panel of the drone using the opening tools and your fingers.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 

                    Jacob Matos                     

Member since: 03/25/2022

681 Reputation

                                      4 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges                           

Team

                       UMass Dartmouth, Team F-1, Gurgel Spring 2022                        

                                                  Member of UMass Dartmouth, Team F-1, Gurgel Spring 2022 



                    UMASSD-GURGEL-S22SFG1                     


                                            2 Members                     


                                            6 Guides authored                     

Loïc Sarda - Dec 25, 2022

Reply

Where to buy a new drone body ?