Disassembling Toshiba Nb205 N330Pk Back Panels Repair Guide

Difficulty

Very easy

Steps

Time Required

                          5 minutes

Sections

Disassembling Toshiba NB205 N330PK Back Panels
4 steps

Flags

Markup Mishap

This guide needs better markups. Help out by correcting or making some markup annotations.

Better Introduction

Improve this guide by completing or revising its introduction.

BackToshiba NB205 N330PK
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

What you need

Step 1

              Disassembling Toshiba NB205 N330PK Back Panels

Using the Phillips #0 in the bit driver, carefully loosen and remove the single 5mm screw.
With the retaining screw removed, lift the panel upwards to separate it from the netbook.

Using the Phillips #0 in the bit driver, carefully loosen and remove the single 5mm screw.

With the retaining screw removed, lift the panel upwards to separate it from the netbook.

1024

Step 2

To replace the panel, do step 1 in reverse:
Align the panel slots in the appropriate grooves and set in place.
With the bit driver, replace the screw to secure the RAM panel.

To replace the panel, do step 1 in reverse:

Align the panel slots in the appropriate grooves and set in place.

With the bit driver, replace the screw to secure the RAM panel.

Step 3

Using the bit driver and the Phillips bit, remove both of the panel’s retaining screws.
With the screws removed, lift the panel in the designated direction, as depicted in photo, for removal.
The hard drive is located beneath this cover and is now accessible.

Using the bit driver and the Phillips bit, remove both of the panel’s retaining screws.

With the screws removed, lift the panel in the designated direction, as depicted in photo, for removal.

The hard drive is located beneath this cover and is now accessible.

Step 4

To replace the hard drive panel, do step 3 in reverse:
Place the panel back in its original position and press down.
If the hard drive was removed or replaced during this process, improper installation may prevent the hard drive panel from sitting in the slots properly.
With the bit driver and Phillips bit, replace the two retaining screws to secure the cover plate in place.

To replace the hard drive panel, do step 3 in reverse:

Place the panel back in its original position and press down.

If the hard drive was removed or replaced during this process, improper installation may prevent the hard drive panel from sitting in the slots properly.

With the bit driver and Phillips bit, replace the two retaining screws to secure the cover plate in place.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 5 other contributors

                    Mason McCaskill

Member since: 10/18/2013

1,000 Reputation

                                      9 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       Clemson, Team 14-2, Benson Fall 2013                        

                                                  Member of Clemson, Team 14-2, Benson Fall 2013 



                    CLEM-BENSON-F13S14G2                     


                                            3 Members                     


                                            18 Guides authored

Markup Mishap#

Better Introduction#

What you need#

#

#

#

#

#

#

Team#

#

Markup Mishap

Better Introduction

What you need

Team