Difficulty
Moderate
Steps
3
Time Required
15 - 20 minutes
Sections
1
- Back panel
- 3 steps
Flags
2
Action Shots
Be an action hero! This guide needs images that better demonstrate how to perform specific actions.
Needs Better Images
Better photos will improve this guide. Help out by taking, editing, or uploading new ones!
BackToshiba A1304T
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
If you can’t get a hold of a Torx 6 Security Screwdriver, a small flathead can be used as a substitute
What you need
Step 1
Back panel
- Using a thumb-tack, push-pin, or similar pin, remove the four plastic stoppers located on the back panel.
Using a thumb-tack, push-pin, or similar pin, remove the four plastic stoppers located on the back panel.
1024
Step 2
- With the T8 Torx Security Bit Screwdriver, remove the four screws in the designated locations.
- The T8 Torx Security Bit Screwdriver can be substituted with a small flathead screwdriver. Screw removal may be slightly more difficult however.
With the T8 Torx Security Bit Screwdriver, remove the four screws in the designated locations.
The T8 Torx Security Bit Screwdriver can be substituted with a small flathead screwdriver. Screw removal may be slightly more difficult however.
Step 3
- If needed, use the flathead screwdriver to gently pry the panel from the phone.
- Using your fingers, lift the panel from the device.
If needed, use the flathead screwdriver to gently pry the panel from the phone.
Using your fingers, lift the panel from the device.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 4 other contributors
Christopher
Member since: 04/22/2010
90 Reputation
8 Guides authored
Badges:
7
+4 more badges
Team
Cal Poly, Team 16-6, Maness Spring 2010
Member of Cal Poly, Team 16-6, Maness Spring 2010
CPSU-MANESS-S10S16G6
4 Members
16 Guides authored