Disassembling The Ematic Genesis Repair Guide

Difficulty

Moderate

Steps

3

Time Required

Suggest a time??

Sections

1

• Ematic Genesis Casing
• 3 steps

Flags

Better Introduction

Improve this guide by completing or revising its introduction.

• BackEmatic Genesis

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

What you need

Step 1

              Ematic Genesis Casing               

• Unscrew the two (2) 1.3mm Phillips #00 screws found on the bottom edge of the tablet, where the power and volume buttons are located.

Unscrew the two (2) 1.3mm Phillips #00 screws found on the bottom edge of the tablet, where the power and volume buttons are located.

1024

Step 2

• Insert plastic opening tool into the edge between the screen plate and the back plate to create a separation between the casings.
• Insert the flat end of the spudger next to the plastic opening tool and carefully pry the edges apart. Continue this all around the edges until the casings separate.
• There may be cracking sounds when prying them apart. If carefully done, this is only the locks coming apart and is not harmful.
• Be careful when separating the two plates as they are connected by the speaker wires and could be disconnected during this process.

Insert plastic opening tool into the edge between the screen plate and the back plate to create a separation between the casings.

Insert the flat end of the spudger next to the plastic opening tool and carefully pry the edges apart. Continue this all around the edges until the casings separate.

There may be cracking sounds when prying them apart. If carefully done, this is only the locks coming apart and is not harmful.

Be careful when separating the two plates as they are connected by the speaker wires and could be disconnected during this process.

Step 3

• Remove back plate from screen plate and lay both down flat next to each other.
• Be careful when separating the two plates as they are connected by the speaker wires and could be disconnected during this process.

Remove back plate from screen plate and lay both down flat next to each other.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 

                    Justin Rohrman                     

Member since: 03/23/2015

745 Reputation

                                      6 Guides authored                  



                       Badges:
                       12







                                                        +9 more badges                           

Team

                       Baylor, Team 4-3, Williams Spring 2015                        

                                                  Member of Baylor, Team 4-3, Williams Spring 2015 



                    BU-WILLIAMS-S15S4G3                     


                                            3 Members                     


                                            12 Guides authored