Disassembling Sony Cyber Shot Dsc W330 Outer Casing Repair Guide

Difficulty

Easy

Steps

5

Time Required

                          10 minutes            

Sections

1

• Outer Casing
• 5 steps

Flags

0

• BackSony Cyber-Shot DSC-W330

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Outer Casing               

• Begin by placing the camera flat against a surface and remove the nine (9) black screws. Each screw is of the same length and can be used interchangeably
• Note: There are two (2) screws on each side, and five (5) on the bottom edge.

Begin by placing the camera flat against a surface and remove the nine (9) black screws. Each screw is of the same length and can be used interchangeably

Note: There are two (2) screws on each side, and five (5) on the bottom edge.

1024

Step 2

• Use a plastic opening tool to carefully pry off the front casing.
• Be careful to not to force the casing off. Simply move around the entire case separating where needed.

Use a plastic opening tool to carefully pry off the front casing.

Be careful to not to force the casing off. Simply move around the entire case separating where needed.

Step 3

• Flip the camera over 180 degrees and similarly pry off the rear casing.

Flip the camera over 180 degrees and similarly pry off the rear casing.

Step 4

• Once the outer casings have been removed, the silver side trim should come loose from the camera.
• Place the camera with the lens facing down. Use the plastic opening tool to pry off the side panel with the USB plug.
• Note: If you wish to remove the top cover, see the LCD Display Replacement to remove the LCD screen before continuing to Step 5

Once the outer casings have been removed, the silver side trim should come loose from the camera.

Place the camera with the lens facing down. Use the plastic opening tool to pry off the side panel with the USB plug.

Note: If you wish to remove the top cover, see the LCD Display Replacement to remove the LCD screen before continuing to Step 5

Step 5

• Place the camera with the lens facing down. Use the phillips head screwdriver to remove the silver screw in the corner near the photo capture button.
• Flip the camera over. Use the plastic opening tool to detach the black clip near the capture button.
• Grasp the top cover and gently remove it from the camera body.

Place the camera with the lens facing down. Use the phillips head screwdriver to remove the silver screw in the corner near the photo capture button.

Flip the camera over. Use the plastic opening tool to detach the black clip near the capture button.

Grasp the top cover and gently remove it from the camera body.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.                                             

Author

                                      with 3 other contributors 

                    Hunter Stewart                     

Member since: 10/18/2013

393 Reputation

                                      3 Guides authored                  



                       Badges:
                       12







                                                        +9 more badges                           

Team

                       Clemson, Team 13-4, Benson Fall 2013                        

                                                  Member of Clemson, Team 13-4, Benson Fall 2013 



                    CLEM-BENSON-F13S13G4                     


                                            3 Members                     


                                            14 Guides authored