Difficulty
Easy
Steps
7
Time Required
5 minutes
Sections
1
- Back Cover
- 7 steps
Flags
0
BackPanasonic Lumix DMC-TZ5
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Cover
- Remove the battery and memory card from the device.
Remove the battery and memory card from the device.
1024
Step 2
- Remove 4 screws from the right side of the camera.
- There are two 3.4mm screws at the top.
- There are two 2.2mm screws at the bottom.
Remove 4 screws from the right side of the camera.
There are two 3.4mm screws at the top.
There are two 2.2mm screws at the bottom.
Step 3
- Remove the single 3.4mm screw on the left side of the camera.
Remove the single 3.4mm screw on the left side of the camera.
Step 4
- Remove 5 screws from the base of the camera.
- There are two 2.2mm screws next to the battery compartment.
- There are three 4mm screws around the tripod mount.
Remove 5 screws from the base of the camera.
There are two 2.2mm screws next to the battery compartment.
There are three 4mm screws around the tripod mount.
Step 5
- Slowly slide the back cover away from the device
- The back casing is held in place by two ribbon cables. Do not pull the back cover too far from the camera.
Slowly slide the back cover away from the device
The back casing is held in place by two ribbon cables. Do not pull the back cover too far from the camera.
Step 6
- Detach both ribbon cables using a spudger.
- Use the tip of the spudger to lift the black clip upward, unlocking the ribbon cable.
Detach both ribbon cables using a spudger.
Use the tip of the spudger to lift the black clip upward, unlocking the ribbon cable.
Step 7
- Remove the back casing from the camera.
Remove the back casing from the camera.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
4 other people completed this guide.
Author
with 5 other contributors
Ben Canfield
Member since: 10/10/2010
406 Reputation
3 Guides authored
Badges:
13
+10 more badges
Team
Cal Poly, Team 9-21, Regan Fall 2010
Member of Cal Poly, Team 9-21, Regan Fall 2010
CPSU-REGAN-F10S9G21
4 Members
14 Guides authored
JR Tan - May 8, 2018
Reply
That is not a disassembly! All is shows is taking the back of the camera off. How about showing how to disassembly the camera down to its individual components and make repairs, like getting the lens to extend of fixing a sticking shutter.
