Difficulty

Moderate

Steps

9

Time Required

Suggest a time??

Sections

3

  • Battery
  • 3 steps
  • Front Cover
  • 3 steps
  • Main Display
  • 3 steps

Flags

0

  • BackNokia 2366i

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Turn off the phone.
  • Position the phone so that the back side is in view.

Turn off the phone.

Position the phone so that the back side is in view.

1024

Step 2

  • Apply pressure on the cover while simultaneously sliding the cover downward.
  • Remove the back battery cover.

Apply pressure on the cover while simultaneously sliding the cover downward.

Remove the back battery cover.

Step 3

  • Insert the spudger between the base of the phone and the phone battery.
  • Position the phone so that the battery won’t fall out of the phone.
  • Carefully lift the battery out of the phone.
  • The battery lifts out of the phone easily.

Insert the spudger between the base of the phone and the phone battery.

Position the phone so that the battery won’t fall out of the phone.

Carefully lift the battery out of the phone.

The battery lifts out of the phone easily.

Step 4

              Front Cover
  • Keep the phone closed.
  • Hold the phones sideways with the front cover of the phone facing up.

Keep the phone closed.

Hold the phones sideways with the front cover of the phone facing up.

Step 5

  • Find the slight crease on the side that divides the display assembly in half.
  • Slowly wedge the spudger into the crease.
  • It’s a little difficult to perform this step because the crease is narrow. Do not rush because you may damage the phone

Find the slight crease on the side that divides the display assembly in half.

Slowly wedge the spudger into the crease.

It’s a little difficult to perform this step because the crease is narrow. Do not rush because you may damage the phone

Step 6

  • Run the spudger all along the crease while lifting up.
  • Separate the front cover from the front base.

Run the spudger all along the crease while lifting up.

Separate the front cover from the front base.

Step 7

              Main Display
  • Remove the four 5mm screws on the metal casing using the T6 Torx screwdriver.

Remove the four 5mm screws on the metal casing using the T6 Torx screwdriver.

Step 8

  • Using the spudger, disconnect the green display cable.

Using the spudger, disconnect the green display cable.

Step 9

  • Lift the metal casing.
  • Be careful not to pull the casing too hard because it is still attached to the phone by a wire.
  • Remove the main display from under the metal casing.

Lift the metal casing.

Be careful not to pull the casing too hard because it is still attached to the phone by a wire.

Remove the main display from under the metal casing.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 6 other contributors 


                    Michael Machado

Member since: 01/21/2011

334 Reputation

                                      3 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       Cal Poly, Team 1-14, Amido Winter 2011                        

                                                  Member of Cal Poly, Team 1-14, Amido Winter 2011 



                    CPSU-AMIDO-W11S1G14                     


                                            5 Members                     


                                            16 Guides authored