Difficulty
Easy
Steps
6
Time Required
5 minutes
Sections
1
- Stand
- 6 steps
Flags
0
BackNEC MultiSync LCD1770NX
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
Before beginning this guide, prepare a clean, flat surface to use as a workstation. Avoid working over carpeting, as small screws are used and, if dropped, may be lost in the carpet.
What you need
Step 1
Stand
- Place the monitor face down on a clean, flat surface.
Place the monitor face down on a clean, flat surface.
1024
Step 2
- Firmly remove the back panel of the stand by pulling it up and away from the monitor.
Firmly remove the back panel of the stand by pulling it up and away from the monitor.
Step 3
- Unscrew the two 6mm Phillips PH2 screws to detach the stand enclosure from the stand.
Unscrew the two 6mm Phillips PH2 screws to detach the stand enclosure from the stand.
Step 4
- Firmly grasp the stand enclosure with your hand and slide it to base of stand.
Firmly grasp the stand enclosure with your hand and slide it to base of stand.
Step 5
- Unscrew the two 14.5mm Phillips PH2 screws holding the stand to the monitor.
Unscrew the two 14.5mm Phillips PH2 screws holding the stand to the monitor.
Step 6
- Lift the the stand straight up to remove it.
Lift the the stand straight up to remove it.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 6 other contributors
Michela Upson
Member since: 10/17/2013
107 Reputation
1 Guide authored
Badges:
6
+3 more badges
Team
Cal Poly, Team 11-36, Amido Fall 2013
Member of Cal Poly, Team 11-36, Amido Fall 2013
CPSU-AMIDO-F13S11G36
5 Members
7 Guides authored
