Difficulty
Easy
Steps
8
Time Required
5 - 10 minutes
Sections
2
- Battery
- 2 steps
- Back Cover
- 6 steps
Flags
0
BackKodak Easyshare C813
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Turn off camera by firmly pressing the power button that is located on the top of the camera near the selector dial.
Turn off camera by firmly pressing the power button that is located on the top of the camera near the selector dial.
1024
Step 2
- Press thumb firmly on battery door and slide it in the direction of the arrow.
- Lift thumb allowing the door to swing open.
Press thumb firmly on battery door and slide it in the direction of the arrow.
Lift thumb allowing the door to swing open.
Step 3
Back Cover
- Before removing back cover, it is advisable to use an anti-static wrist strap to prevent damage to electronics.
Before removing back cover, it is advisable to use an anti-static wrist strap to prevent damage to electronics.
Step 4
- Turn the camera off by firmly pressing the power button located on top of the camera.
Turn the camera off by firmly pressing the power button located on top of the camera.
Step 5
- Locate the 7 screws holding the back cover on.
- Three screws are located on the bottom of the camera.
- Two screws are located on the side shown in the photograph.
- Two final screws are located on the opposite side shown in the photograph.
Locate the 7 screws holding the back cover on.
Three screws are located on the bottom of the camera.
Two screws are located on the side shown in the photograph.
Two final screws are located on the opposite side shown in the photograph.
Step 6
- Remove all 7 screws:
- Hold the camera firmly with one hand so that you can still see a screw.
- Place the Philips 00(Found here)screwdriver into the screw.
- Turn the screwdriver to the left until it is free.
- Repeat for the remaining screws.
Remove all 7 screws:
Hold the camera firmly with one hand so that you can still see a screw.
Place the Philips 00(Found here)screwdriver into the screw.
Turn the screwdriver to the left until it is free.
Repeat for the remaining screws.
Step 7
- Use plastic opening tools to slightly open the side of the case.
- Insert a plastic opening tool and apply pressure to the internal three tabs at the top.
- The first two are near the words “3X Optical Zoom”.
- The third is near the shutter button.
Use plastic opening tools to slightly open the side of the case.
Insert a plastic opening tool and apply pressure to the internal three tabs at the top.
The first two are near the words “3X Optical Zoom”.
The third is near the shutter button.
Step 8
- Gently pull apart the back cover from the rest of the camera.
- Make sure there are no more screws or tabs keeping the cover on.
- Use the plastic opening tool to separate any sides still closely connected.
Gently pull apart the back cover from the rest of the camera.
Make sure there are no more screws or tabs keeping the cover on.
Use the plastic opening tool to separate any sides still closely connected.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 6 other contributors
Susan Marano
Member since: 04/15/2010
318 Reputation
7 Guides authored
Badges:
16
+13 more badges
Team
Cal Poly, Team 24-22, Regan Spring 2010
Member of Cal Poly, Team 24-22, Regan Spring 2010
CPSU-REGAN-S10S24G22
4 Members
20 Guides authored
