Difficulty

Easy

Steps

3

Time Required

Suggest a time??

Sections

1

  • Main body
  • 3 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackKenwood TM-241A

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Main body
  • Push down on the tab that locks the power connection together, and slide the two connectors apart.
  • Unscrew the antenna downlead from the antenna pigtail coming out of the radio, and pull the two apart.
  • Unscrew the microphone connector from the front panel of the radio, and pull it out.

Push down on the tab that locks the power connection together, and slide the two connectors apart.

Unscrew the antenna downlead from the antenna pigtail coming out of the radio, and pull the two apart.

Unscrew the microphone connector from the front panel of the radio, and pull it out.

1024

Step 2

  • Using a #1 phillips screwdriver, remove the two screws that secure the top cover to the radio.
  • Do the same to the two screws on the bottom.

Using a #1 phillips screwdriver, remove the two screws that secure the top cover to the radio.

Do the same to the two screws on the bottom.

Step 3

  • There are two tabs that sit underneath the sides of the face plate. They have a tendency to break out the plastic over top of them while removing the covers. To help prevent this, push inward on the side of the cover, just behind the face plate as you take off the covers.
  • Lift up on the rear of the top cover, and slide it towards the back of the radio to disengage the three tabs at the front.
  • Repeat for the bottom cover of the radio.

There are two tabs that sit underneath the sides of the face plate. They have a tendency to break out the plastic over top of them while removing the covers. To help prevent this, push inward on the side of the cover, just behind the face plate as you take off the covers.

Lift up on the rear of the top cover, and slide it towards the back of the radio to disengage the three tabs at the front.

Repeat for the bottom cover of the radio.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Josh

Member since: 03/22/2013

707 Reputation

                                      4 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges