Disassembling Insignia Ns B2110 Bottom Panel Repair Guide

Difficulty

Moderate

Steps

Time Required

                          10 minutes

Sections

Battery
2 steps
Bottom Panel
3 steps

Flags

BackInsignia NS-B2110
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Battery

Flip the stereo so the CD opening is face down.
With two fingers, pinch the tabs and lift up to open the battery protection cover.

Flip the stereo so the CD opening is face down.

With two fingers, pinch the tabs and lift up to open the battery protection cover.

1024

Step 2

Using a spudger or your fingers, push up against the positive end of the battery. Once it is loose, lift the battery out.
Repeat until all eight batteries are removed.
Make sure the batteries are facing the right direction. If the device does not turn on, you may have the batteries in the opposite orientation.

Using a spudger or your fingers, push up against the positive end of the battery. Once it is loose, lift the battery out.

Repeat until all eight batteries are removed.

Make sure the batteries are facing the right direction. If the device does not turn on, you may have the batteries in the opposite orientation.

Step 3

              Bottom Panel

With a Phillips #2 screwdriver, remove two 2mm screws.

With a Phillips #2 screwdriver, remove two 2mm screws.

Step 4

Using a long Phillips #2 screwdriver, remove one 6mm screw located inside the battery compartment.
Use the same screwdriver to remove four more 6mm screws along the outside of the case.

Using a long Phillips #2 screwdriver, remove one 6mm screw located inside the battery compartment.

Use the same screwdriver to remove four more 6mm screws along the outside of the case.

Step 5

With a plastic opening tool, wedge the bottom shell from the main speaker face along the edge.
The bottom cover has two red and two yellow wires attached to it that you don’t want to pull off. Handle the casing carefully.
Once the pieces are separated, pull them apart and place the bottom cover aside, near the stereo.

With a plastic opening tool, wedge the bottom shell from the main speaker face along the edge.

The bottom cover has two red and two yellow wires attached to it that you don’t want to pull off. Handle the casing carefully.

Once the pieces are separated, pull them apart and place the bottom cover aside, near the stereo.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors

                    Nikki

Member since: 10/14/2013

104 Reputation

                                      1 Guide authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       Cal Poly, Team 4-31, Amido Fall 2013                        

                                                  Member of Cal Poly, Team 4-31, Amido Fall 2013 



                    CPSU-AMIDO-F13S4G31                     


                                            4 Members                     


                                            8 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team