Difficulty
Easy
Steps
5
Time Required
10 minutes
Sections
1
- External Shell
- 5 steps
Flags
0
BackInFocus LP435Z
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
External Shell
- Place the projector on its back (buttons down) with the lens facing away from you.
- Remove the two 84mm screws in the upper left and right corners of the projector using the Phillips #2 screwdriver.
- Remove the remaining three 8.5mm screws using the Phillips #1 screwdriver.
Place the projector on its back (buttons down) with the lens facing away from you.
Remove the two 84mm screws in the upper left and right corners of the projector using the Phillips #2 screwdriver.
Remove the remaining three 8.5mm screws using the Phillips #1 screwdriver.
1024
Step 2
- Use the plastic opening tools to push down the clips holding the lamp cover in place, and remove it.
- There is no lamp assembly in the projector used in this guide, yours may appear different.
Use the plastic opening tools to push down the clips holding the lamp cover in place, and remove it.
There is no lamp assembly in the projector used in this guide, yours may appear different.
Step 3
- Remove the two 8.5mm rear screws holding the rear case plate to the projector using the Phillips #1 screwdriver.
- Pull the rear plate straight off and set it aside.
Remove the two 8.5mm rear screws holding the rear case plate to the projector using the Phillips #1 screwdriver.
Pull the rear plate straight off and set it aside.
Step 4
- Flip the projector over and turn around so that the lens faces you.
- Twist the gray zoom adjustment ring clockwise and extend the lens all the way out, and then slide the zoom adjustment ring all the way towards the end of the lens as far as it will go.
- Slide the front case plate towards the loosened zoom adjustment ring, until the top plate of the projector is freed from underneath the lip of the front case plate.
- The front case plate will not come all the way off due to the zoom adjustment ring obstructing it. It will merely slide forward a bit.
Flip the projector over and turn around so that the lens faces you.
Twist the gray zoom adjustment ring clockwise and extend the lens all the way out, and then slide the zoom adjustment ring all the way towards the end of the lens as far as it will go.
Slide the front case plate towards the loosened zoom adjustment ring, until the top plate of the projector is freed from underneath the lip of the front case plate.
The front case plate will not come all the way off due to the zoom adjustment ring obstructing it. It will merely slide forward a bit.
Step 5
- Lift away the top case plate and set it aside.
Lift away the top case plate and set it aside.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 5 other contributors
Andrew Kennedy
Member since: 01/29/2013
186 Reputation
6 Guides authored
Badges:
10
+7 more badges
Team
Cal Poly, Team 20-3, Maness Winter 2013
Member of Cal Poly, Team 20-3, Maness Winter 2013
CPSU-MANESS-W13S20G3
4 Members
6 Guides authored
