Difficulty

Moderate

Steps

6

Time Required

                          5 - 10 minutes

Sections

3

  • Phone Cord
  • 2 steps
  • 9V Base Battery
  • 1 step
  • Disassembling General Electric Telephone 2-9710A Base Shell
  • 3 steps

Flags

1

Missed a Step

Oops! This guide is currently missing some important steps.

  • BackGeneral Electric Telephone 2-9710A

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Phone Cord
  • Unplug the device before proceeding.
  • Using a plastic opening tool, remove the phone cord from the phone jack at the base of the headset.
  • To release the cable gently, press down on the top plastic tab of the connector.

Unplug the device before proceeding.

Using a plastic opening tool, remove the phone cord from the phone jack at the base of the headset.

To release the cable gently, press down on the top plastic tab of the connector.

1024

Step 2

  • Remove the 7.5mm screw.
  • Remove the screw cap.
  • Pull up the phone cord to remove from the base.

Remove the 7.5mm screw.

Remove the screw cap.

Pull up the phone cord to remove from the base.

Step 3

              9V Base Battery
  • Remove the battery compartment door (located on the bottom of the radio) by applying thumb pressure to the area indicated on the battery door and then sliding the door off the cabinet.
  • Remove the battery from the phone.

Remove the battery compartment door (located on the bottom of the radio) by applying thumb pressure to the area indicated on the battery door and then sliding the door off the cabinet.

Remove the battery from the phone.

Step 4

              Remove Volume Dial
  • Ensure phone is unplugged from phone jack and electrical source.
  • Locate the volume dial on the right side of the telephone.
  • Remove the volume dial by gently grasping the dial and pulling away from the base.

Ensure phone is unplugged from phone jack and electrical source.

Locate the volume dial on the right side of the telephone.

Remove the volume dial by gently grasping the dial and pulling away from the base.

Step 5

              Remove Screws on the Back
  • Remove the three 12mm screws with the Phillips #1 screwdriver.
  • Remove the three 18mm screws with the Phillips #1 screwdriver.

Remove the three 12mm screws with the Phillips #1 screwdriver.

Remove the three 18mm screws with the Phillips #1 screwdriver.

Step 6

              Pry the Back Off
  • Pry off the base shell using a plastic opener tool.
  • Set shell aside and you now have access to the internal components of the General Electric Telephone 2-9710A.

Pry off the base shell using a plastic opener tool.

Set shell aside and you now have access to the internal components of the General Electric Telephone 2-9710A.

Reassemble your devise by following these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 6 other contributors 


                    Alles Rebel

Member since: 09/20/2012

72 Reputation

                                      3 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       Cal Poly, Team 16-59, Forte Fall 2012                        

                                                  Member of Cal Poly, Team 16-59, Forte Fall 2012 



                    CPSU-FORTE-F12S16G59                     


                                            4 Members                     


                                            16 Guides authored