Difficulty

Easy

Steps

6

Time Required

                          5 - 10 minutes

Sections

1

  • Bottom Base
  • 6 steps

Flags

2

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackGD Midea FT30-3D

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Bottom Base
  • Locate and remove the 14.5 mm Phillips #1 screw on the bottom of the fan base.

Locate and remove the 14.5 mm Phillips #1 screw on the bottom of the fan base.

1024

Step 2

  • Locate the gray base support release tabs found on either side pictured in the first image.
  • There are release tabs on each side of the base.
  • Press both release tabs in with the tip of your fingers and pull the gray base support until the tabs are cleared.

Locate the gray base support release tabs found on either side pictured in the first image.

There are release tabs on each side of the base.

Press both release tabs in with the tip of your fingers and pull the gray base support until the tabs are cleared.

Step 3

  • Continue removing the gray base support by pressing your thumb into the circular opening in the base and pulling with your figures on the back side.
  • Notice that on the internal front tip of the base there is a tab. Because of this tab the back end will pivot off at that point.

Continue removing the gray base support by pressing your thumb into the circular opening in the base and pulling with your figures on the back side.

Notice that on the internal front tip of the base there is a tab. Because of this tab the back end will pivot off at that point.

Step 4

  • After the base has separated more it will be easy to fully remove it. Continue pulling the back edge of the gray base support, rotating it around the front tab until it comes off completely.

After the base has separated more it will be easy to fully remove it. Continue pulling the back edge of the gray base support, rotating it around the front tab until it comes off completely.

Step 5

  • Remove the following five 14.5 mm Phillips #1 screws found on the bottom.
  • All of the screws are recessed by 17.5 mm, so ensure your screwdriver can reach that far.

Remove the following five 14.5 mm Phillips #1 screws found on the bottom.

All of the screws are recessed by 17.5 mm, so ensure your screwdriver can reach that far.

Step 6

  • Once all five screws have been removed the base cover should fall right off with out any effort.
  • When putting the base cover back on; be careful to make sure that none of the wires are pinched.

Once all five screws have been removed the base cover should fall right off with out any effort.

When putting the base cover back on; be careful to make sure that none of the wires are pinched.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 2 other contributors 


                    Chris Hartley

Member since: 10/04/2012

417 Reputation

                                      3 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       Cal Poly, Team 24-28, Regan Fall 2012                        

                                                  Member of Cal Poly, Team 24-28, Regan Fall 2012 



                    CPSU-REGAN-F12S24G28                     


                                            4 Members                     


                                            14 Guides authored