Difficulty
Easy
Steps
6
Time Required
15 - 30 minutes
Sections
1
- Logic Board
- 6 steps
Flags
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
BackGarmin Nuvi 1200
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Logic Board
- Remove to sticker on the back of the unit and then remove the two T5 scremws once this is done use a spudger to carefully pry off the silver cover.
- Once the tool is inserted it can slide around the entire device.
Remove to sticker on the back of the unit and then remove the two T5 scremws once this is done use a spudger to carefully pry off the silver cover.
Once the tool is inserted it can slide around the entire device.
1024
Step 2
- Remove four small T5 torx screws.
- Be gentle, the screws are easily stripped.
Remove four small T5 torx screws.
Be gentle, the screws are easily stripped.
Step 3
- Lift cover off of unit.
- Be careful not to lose small rubber piece on the bottom right corner.
Lift cover off of unit.
Be careful not to lose small rubber piece on the bottom right corner.
Step 4
- Disconnect ribbon cable from logic board.
Disconnect ribbon cable from logic board.
Step 5
- Remove two T5 torx screws holding down logic board.
- Disconnect battery.
Remove two T5 torx screws holding down logic board.
Disconnect battery.
Step 6
- Gently lift the logic board out of the unit
- Be careful not to damage the battery connector on the top of the unit.
Gently lift the logic board out of the unit
Be careful not to damage the battery connector on the top of the unit.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
6 other people completed this guide.
Author
with 1 other contributor
Zachary Landau
Member since: 11/28/2010
206 Reputation
1 Guide authored
Badges:
8
+5 more badges