Difficulty
Very easy
Steps
7
Time Required
1 minute
Sections
2
- Back Cover
- 4 steps
- Front Cover
- 3 steps
Flags
1
Step Trimmer
This guide has unnecessary steps. Trim them to be more concise!
BackCanon PowerShot SD800 IS
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Cover
- Remove one 2.25mm screw on the bottom.
Remove one 2.25mm screw on the bottom.
1024
Step 2
- Remove two 2.25mm screws on the right side looking from the front.
Remove two 2.25mm screws on the right side looking from the front.
Step 3
- Remove one 4.7mm screw on the side with the AV output.
Remove one 4.7mm screw on the side with the AV output.
Step 4
- Pull off the back cover.
- The back cover tends to stick in the top corner (near the mode dial) due to a metal clip. Jiggle the cover side to side as you pull it out.
Pull off the back cover.
The back cover tends to stick in the top corner (near the mode dial) due to a metal clip. Jiggle the cover side to side as you pull it out.
Step 5
Front Cover
- Remove the 3.9mm screw in the AV housing on the left side from the front of the camera.
Remove the 3.9mm screw in the AV housing on the left side from the front of the camera.
Step 6
- Remove one 2.25mm screw on the bottom of the camera.
Remove one 2.25mm screw on the bottom of the camera.
Step 7
- Pull off the front cover.
Pull off the front cover.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Jeremy Rabaino
Member since: 10/10/2010
135 Reputation
6 Guides authored
Badges:
7
+4 more badges
Team
Cal Poly, Team 20-9, Maness Fall 2010
Member of Cal Poly, Team 20-9, Maness Fall 2010
CPSU-MANESS-F10S20G9
5 Members
6 Guides authored
