Difficulty
Moderate
Steps
10
Time Required
10 - 20 minutes
Sections
2
- Front and Rear Cover
- 4 steps
- LCD screen
- 6 steps
Flags
0
BackCanon PowerShot SD1100 IS
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Front and Rear Cover
- Remove wrist strap and battery.
Remove wrist strap and battery.
1024
Step 2
- Remove 2 screws from each side of the camera (4 total, 0.102 in).
- Remove 2 screws from the bottom on the camera (0.138 in).
- Do not mix the 4 side screws with the 2 bottoms ones; they are different sizes.
Remove 2 screws from each side of the camera (4 total, 0.102 in).
Remove 2 screws from the bottom on the camera (0.138 in).
Do not mix the 4 side screws with the 2 bottoms ones; they are different sizes.
Step 3
- Gently pull off the front cover.
- The plate on the side should come off.
- Gently pull off the back cover.
Gently pull off the front cover.
The plate on the side should come off.
Gently pull off the back cover.
Step 4
- The cases should now be removed.
The cases should now be removed.
Step 5
LCD screen
- Remove the top-left screw above the LCD screen (0.100 in).
- Remove the C-shaped plate from the side of the LCD screen.
Remove the top-left screw above the LCD screen (0.100 in).
Remove the C-shaped plate from the side of the LCD screen.
Step 6
- Remove the screw from the top-right of the LCD screen (0.098 in).
- Remove the L-shaped bar from the right of the LCD screen.
Remove the screw from the top-right of the LCD screen (0.098 in).
Remove the L-shaped bar from the right of the LCD screen.
Step 7
- Use the spudger to remove the L-shaped bar from the left-side of the LCD screen.
Use the spudger to remove the L-shaped bar from the left-side of the LCD screen.
Step 8
- Use tweezers to remove the connector ribbon from the top-left corner above the LCD screen.
- Be gentle. This ribbon should stay attached to the screen.
Use tweezers to remove the connector ribbon from the top-left corner above the LCD screen.
Be gentle. This ribbon should stay attached to the screen.
Step 9
- Use a spudger to lift the connector lock (black flap) at the end of the larger LCD connector ribbon on the front side of the camera.
- Use the tweezers to lift this ribbon.
- Use the tweezers to gently peel this ribbon from the one underneath it.
Use a spudger to lift the connector lock (black flap) at the end of the larger LCD connector ribbon on the front side of the camera.
Use the tweezers to lift this ribbon.
Use the tweezers to gently peel this ribbon from the one underneath it.
Step 10
- The LCD screen should now be removed.
The LCD screen should now be removed.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
3 other people completed this guide.
Author
with 6 other contributors
Tyler Grossheim
Member since: 01/25/2011
1,470 Reputation
6 Guides authored
Badges:
14
+11 more badges
Team
Cal Poly, Team 3-32, Regan Winter 2011
Member of Cal Poly, Team 3-32, Regan Winter 2011
CPSU-REGAN-W11S3G32
3 Members
8 Guides authored
