Difficulty

Moderate

Steps

6

Time Required

                          10 - 15 minutes

Sections

2

  • Rear Cover
  • 3 steps
  • Disassembling Arnova 7K G3 Logic Board Ribbon Connectors
  • 3 steps

Flags

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

Step Trimmer

This guide has unnecessary steps. Trim them to be more concise!

  • BackArnova 7K G3

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Rear Cover
  • Remove four 5 mm Phillips #00 screws from each corner of the tablet.

Remove four 5 mm Phillips #00 screws from each corner of the tablet.

1024

Step 2

  • Place the iFixit opening tool in the notches between the cases and pull the covers apart.

Place the iFixit opening tool in the notches between the cases and pull the covers apart.

Step 3

  • Repeat step two until 3/4 of the rear cover is unlatched.
  • Proceed to remove the rear cover by gently pulling it apart by hand.

Repeat step two until 3/4 of the rear cover is unlatched.

Proceed to remove the rear cover by gently pulling it apart by hand.

Step 4

              Disassembling Arnova 7K G3 Logic Board Ribbon Connectors
  • Peel the copper tape covering the ribbon connector with a set of tweezers.

Peel the copper tape covering the ribbon connector with a set of tweezers.

Step 5

  • Locate the two gray pins on the ribbon connector.
  • Grab the first pin with tweezers and gently pull it towards the ribbon. Repeat the step.
  • Gently pull the ribbon cable out of the connection port.

Locate the two gray pins on the ribbon connector.

Grab the first pin with tweezers and gently pull it towards the ribbon. Repeat the step.

Gently pull the ribbon cable out of the connection port.

Step 6

  • Locate the ribbon connector two.
  • Locate the pins of ribbon connector two. Repeat step two for unlocking the pins.
  • Gently pull the ribbon out of the connection port.

Locate the ribbon connector two.

Locate the pins of ribbon connector two. Repeat step two for unlocking the pins.

Gently pull the ribbon out of the connection port.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 


                    Kue

Member since: 03/18/2015

301 Reputation

                                      3 Guides authored                  



                       Badges:
                       4







                                                        +1 more badge

Team

                       Michigan Tech, Team 1-2, Lauer Spring 2015                        

                                                  Member of Michigan Tech, Team 1-2, Lauer Spring 2015 



                    MTU-LAUER-S15S1G2                     


                                            2 Members                     


                                            10 Guides authored