Difficulty

Easy

Steps

5

Time Required

                          15 - 30 minutes

Sections

1

  • Disassembling 2010-2014 Ford Mustang Center Console
  • 5 steps

Flags

3

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

Needs More Images

A few more images would make this guide’s procedures crystal clear.

Missed a Step

Oops! This guide is currently missing some important steps.

  • Back2010-2014 Ford Mustang

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Disassembling 2010-2014 Ford Mustang Center Console
  • Open the rear part of the middle console.

Open the rear part of the middle console.

1024

Step 2

  • Grip the right side of the console and pull up towards the passenger seat to remove it.

Grip the right side of the console and pull up towards the passenger seat to remove it.

Step 3

  • Locate the two bolts under the air conditioning controls at the bottom of the face plate.
  • Loosen these two bolts with a basic socket wrench suited for 7mm bolts.

Locate the two bolts under the air conditioning controls at the bottom of the face plate.

Loosen these two bolts with a basic socket wrench suited for 7mm bolts.

Step 4

  • Wedge a spudger or plastic opening tool (in place of the screwdriver shown) under the top of the face plate.
  • Apply pressure until the corners “pop” out of place.

Wedge a spudger or plastic opening tool (in place of the screwdriver shown) under the top of the face plate.

Apply pressure until the corners “pop” out of place.

Step 5

  • Inspect the interior of the center console for damaged wires or other faulty components.

Inspect the interior of the center console for damaged wires or other faulty components.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      13 other people completed this guide.

Author

                                      with 9 other contributors 


                    Christopher Pell

Member since: 09/26/2012

239 Reputation

                                      5 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       Cal Poly, Team 15-45, Forte Fall 2012                        

                                                  Member of Cal Poly, Team 15-45, Forte Fall 2012 



                    CPSU-FORTE-F12S15G45                     


                                            5 Members                     


                                            6 Guides authored

Zack - Apr 14, 2016

Reply

Were can I get that faceplate connector and the connectors for the sterio…I have a 2010 v6 mustang

beauxvader - Sep 14, 2018

I found a replacement but need wire configuration for the 4 wires can anyone help ?

hotmail1hotmail - May 23, 2017

Reply

Try using the correct tool to remove panels…

davidwest805 - May 27, 2017

Reply

The screwdriver is not required. Nor is any other tool at that point. GENTLY pull from the tabs where you removed the screws.

The faceplate will begin to loosen from the bottom up. After pulling out a few inches, push back inward about a half of an inch. This has the effect of a teeter/totter on the remaining top wedge pins. Now grasp the two knobs on the bottom of the panel (fan and temp) and loosen first the left side and then the right side. No real force required at any time and practically falls out. NO SCARS on the trim.

cheers,

dbw -