Difficulty
Moderate
Steps
4
Time Required
Suggest a time??
Sections
1
- Motor
- 4 steps
Flags
0
BackDirt Devil Scorpion Quick Flip
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Motor
- Gently remove filter adapter from the vacuum body by pressing the gray plastic release button.
Gently remove filter adapter from the vacuum body by pressing the gray plastic release button.
1024
Step 2
- Place the vacuum body on its left side and remove all 4mm screws with a Phillips #1 screwdriver.
Place the vacuum body on its left side and remove all 4mm screws with a Phillips #1 screwdriver.
Step 3
- Carefully take apart the shell of the vacuum body.
- Cut the two wires attached to the motor and remove the motor from the body.
Carefully take apart the shell of the vacuum body.
Cut the two wires attached to the motor and remove the motor from the body.
Step 4
- Solder the wires from the replacement motor to the wires connecting it to the power cord.
- Carefully place the replacement motor back into its correct position in the vacuum body.
- Check out our How to Solder and Desolder Connections guide if you are unfamiliar with the soldering process.
Solder the wires from the replacement motor to the wires connecting it to the power cord.
Carefully place the replacement motor back into its correct position in the vacuum body.
Check out our How to Solder and Desolder Connections guide if you are unfamiliar with the soldering process.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Adam Mooney
Member since: 10/02/2019
109 Reputation
1 Guide authored
Badges:
3
Team
The Citadel Military College of South Carolina, Team S3-G14, Eggleston Fall 2019
Member of The Citadel Military College of South Carolina, Team S3-G14, Eggleston Fall 2019
CMCSC-EGGLESTON-F19S3G14
3 Members
3 Guides authored