Digitech Xc 5206 Motherboard Replacement Repair Guide

Difficulty

Moderate

Steps

7

Time Required

                          20 - 25 minutes            

Sections

1

• Motherboard
• 7 steps

Flags

0

• BackDigitech XC- 5206 Bluetooth Speaker

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Motherboard               

• Remove front panel by forcefully placing the flat edge of the spudger in between panel and plastic. Angle spudger and use fingers to pry panel off. You may need to use extra force.

Remove front panel by forcefully placing the flat edge of the spudger in between panel and plastic. Angle spudger and use fingers to pry panel off. You may need to use extra force.

1024

Step 2

• Unscrew all eight 14mm screws closest to the edges of the speaker by spinning a size PH2 screwdriver in a counterclockwise motion.
• Dislodge face by holding speaker face down. Gently shake or tap front against table to fully remove face.
• OR grab ahold of the silver tab to pull the speaker face out. This may require force.

Unscrew all eight 14mm screws closest to the edges of the speaker by spinning a size PH2 screwdriver in a counterclockwise motion.

Dislodge face by holding speaker face down. Gently shake or tap front against table to fully remove face.

OR grab ahold of the silver tab to pull the speaker face out. This may require force.

Step 3

• Cut zip-ties wrapped around red and green wires using scissors or pliers.

Cut zip-ties wrapped around red and green wires using scissors or pliers.

Step 4

• Pull wires out of ports using blunt nose tweezers.

Pull wires out of ports using blunt nose tweezers.

Step 5

• Unscrew two 10 mm screws below connecting motherboard to speaker system by spinning a Phillips PH2 bit screwdriver in a counterclockwise motion.

Unscrew two 10 mm screws below connecting motherboard to speaker system by spinning a Phillips PH2 bit screwdriver in a counterclockwise motion.

Step 6

• Pull motherboard out of slot using the angled tweezers and blunt nose tweezers on each side.

Pull motherboard out of slot using the angled tweezers and blunt nose tweezers on each side.

Step 7

• Remove motherboard from white wire strip by pulling the two apart using blunt nose tweezers on one side and fingers on wire strip plug.

Remove motherboard from white wire strip by pulling the two apart using blunt nose tweezers on one side and fingers on wire strip plug.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 

                    Kassidy Wyckoff                     

Member since: 10/02/2018

655 Reputation

                                      4 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges                           

Team

                       Eastern Washington University, Team S2-G4, Munoz Fall 2018                        

                                                  Member of Eastern Washington University, Team S2-G4, Munoz Fall 2018 



                    EWU-MUNOZ-F18S2G4                     


                                            4 Members                     


                                            4 Guides authored