Difficulty

Difficult

Steps

4

Time Required

                          15 - 20 minutes

Sections

1

  • Dual Speaker
  • 4 steps

Flags

This guide has been the hard work of our awesome students and is found to be exceptionally cool by the iFixit staff.

  • BackDigitech XC- 5206 Bluetooth Speaker

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Dual Speaker
  • Remove the front panel by forcefully placing the flat edge of the spudger in between the panel and the plastic housing.
  • Angle the spudger and use your fingers to pry the panel off.
  • You may need to use extra force.

Remove the front panel by forcefully placing the flat edge of the spudger in between the panel and the plastic housing.

Angle the spudger and use your fingers to pry the panel off.

You may need to use extra force.

1024

Step 2

  • Unscrew all eight 14mm screws closest to the edges of the speaker by spinning a size PH2 screwdriver in a counterclockwise motion.
  • Dislodge face by holding speaker face down. Gently shake or tap front against table to fully remove face.
  • OR grab ahold of the silver tab to pull the speaker face out. This may require force.

Unscrew all eight 14mm screws closest to the edges of the speaker by spinning a size PH2 screwdriver in a counterclockwise motion.

Dislodge face by holding speaker face down. Gently shake or tap front against table to fully remove face.

OR grab ahold of the silver tab to pull the speaker face out. This may require force.

Step 3

  • Unscrew the eight 10mm screws closest to the center of the speakers by spinning a Phillips screwdriver with a PH2 bit in a counterclockwise motion.
  • Push speaker bulbs forward and out of slot.

Unscrew the eight 10mm screws closest to the center of the speakers by spinning a Phillips screwdriver with a PH2 bit in a counterclockwise motion.

Push speaker bulbs forward and out of slot.

Step 4

  • Remove green (left) and red (right) wired connection to speaker bulb using a soldering station.

Remove green (left) and red (right) wired connection to speaker bulb using a soldering station.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 1 other contributor 


                    Kassidy Wyckoff

Member since: 10/02/2018

655 Reputation

                                      4 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       Eastern Washington University, Team S2-G4, Munoz Fall 2018                        

                                                  Member of Eastern Washington University, Team S2-G4, Munoz Fall 2018 



                    EWU-MUNOZ-F18S2G4                     


                                            4 Members                     


                                            4 Guides authored