Difficulty

Easy

Steps

4

Time Required

                          15 - 20 minutes

Sections

1

  • Speaker Buttons
  • 4 steps

Flags

0

  • BackDigitech XC- 5206 Bluetooth Speaker

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Speaker Buttons
  • Remove front panel by forcefully placing the flat edge of the spudger in between panel and plastic. Angle spudger and use fingers to pry panel off.
  • You may need to use extra force.

Remove front panel by forcefully placing the flat edge of the spudger in between panel and plastic. Angle spudger and use fingers to pry panel off.

You may need to use extra force.

1024

Step 2

  • Unscrew all eight 14mm screws closest to the edges of the speaker by spinning a size PH2 screwdriver in a counterclockwise motion.
  • Dislodge face by holding speaker face down. Gently shake or tap front against table to fully remove face.
  • OR grab ahold of the silver tab to pull the speaker face out. This may require force.

Unscrew all eight 14mm screws closest to the edges of the speaker by spinning a size PH2 screwdriver in a counterclockwise motion.

Dislodge face by holding speaker face down. Gently shake or tap front against table to fully remove face.

OR grab ahold of the silver tab to pull the speaker face out. This may require force.

Step 3

  • Unscrew upper panel two 10 mm screws spinning a size PH2 screwdriver in a counterclockwise motion.

Unscrew upper panel two 10 mm screws spinning a size PH2 screwdriver in a counterclockwise motion.

Step 4

  • Remove circuit board by pulling straight upwards out of slot.
  • Remove plastic buttons by gently pushing buttons from top of speaker and using other hand to pull from bottom.

Remove circuit board by pulling straight upwards out of slot.

Remove plastic buttons by gently pushing buttons from top of speaker and using other hand to pull from bottom.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Kassidy Wyckoff

Member since: 10/02/2018

655 Reputation

                                      4 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       Eastern Washington University, Team S2-G4, Munoz Fall 2018                        

                                                  Member of Eastern Washington University, Team S2-G4, Munoz Fall 2018 



                    EWU-MUNOZ-F18S2G4                     


                                            4 Members                     


                                            4 Guides authored