Difficulty
Difficult
Steps
5
Time Required
15 - 30 minutes
Sections
2
- Motherboard
- 4 steps
- Input/Output ¼” Ports
- 1 step
Flags
0
BackDigiTech RP70
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Motherboard
- Unplug the device from its AC power adapter; unplug anything connected to the input/output jacks.
- Remove the four 8mm Phillips #0 screws located on the back panel.
Unplug the device from its AC power adapter; unplug anything connected to the input/output jacks.
Remove the four 8mm Phillips #0 screws located on the back panel.
1024
Step 2
- Remove the back panel to expose the motherboard.
Remove the back panel to expose the motherboard.
Step 3
- Remove the two 11mm #0 Phillips screws located at the bottom of the motherboard.
Remove the two 11mm #0 Phillips screws located at the bottom of the motherboard.
Step 4
- Lift the indented end of the motherboard opposite the input/output jacks. Then, pull away from the input/output jacks to slide the motherboard out of the casing.
Lift the indented end of the motherboard opposite the input/output jacks. Then, pull away from the input/output jacks to slide the motherboard out of the casing.
Step 5
Input/Output ¼” Ports
- Desolder the back of the motherboard where the damaged input/output port is located.
Desolder the back of the motherboard where the damaged input/output port is located.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 3 other contributors
Elijah Smith
Member since: 09/10/2018
726 Reputation
6 Guides authored
Badges:
10
+7 more badges
Team
Appalachian State University, Team S2-G2, Menagarishvili Fall 2018
Member of Appalachian State University, Team S2-G2, Menagarishvili Fall 2018
APSU-MENAGARISHVILI-F18S2G2
3 Members
6 Guides authored
