Difficulty
Difficult
Steps
5
Time Required
15 - 30 minutes
Sections
2
- Motherboard
- 4 steps
- Amp/Mixer Switch
- 1 step
Flags
0
BackDigiTech RP70
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Motherboard
- Unplug the device from its AC power adapter; unplug anything connected to the input/output jacks.
- Remove the four 8mm Phillips #0 screws located on the back panel.
Unplug the device from its AC power adapter; unplug anything connected to the input/output jacks.
Remove the four 8mm Phillips #0 screws located on the back panel.
1024
Step 2
- Remove the back panel to expose the motherboard.
Remove the back panel to expose the motherboard.
Step 3
- Remove the two 11mm #0 Phillips screws located at the bottom of the motherboard.
Remove the two 11mm #0 Phillips screws located at the bottom of the motherboard.
Step 4
- Lift the indented end of the motherboard opposite the input/output jacks. Then, pull away from the input/output jacks to slide the motherboard out of the casing.
Lift the indented end of the motherboard opposite the input/output jacks. Then, pull away from the input/output jacks to slide the motherboard out of the casing.
Step 5
Amp/Mixer Switch
- Desolder the back of the motherboard where you want to replace the switch.
Desolder the back of the motherboard where you want to replace the switch.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Elijah Smith
Member since: 09/10/2018
726 Reputation
6 Guides authored
Badges:
10
+7 more badges
Team
Appalachian State University, Team S2-G2, Menagarishvili Fall 2018
Member of Appalachian State University, Team S2-G2, Menagarishvili Fall 2018
APSU-MENAGARISHVILI-F18S2G2
3 Members
6 Guides authored