Difficulty

Moderate

Steps

7

Time Required

                          15 - 20 minutes

Sections

2

  • External Cover
  • 3 steps
  • Front/Rear Facing Camera
  • 4 steps

Flags

0

  • BackDigital2 Platinum Pad 9

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              External Cover
  • Take the plastic opening tool and insert it into the crease between the screen and the plastic casing and press down.

Take the plastic opening tool and insert it into the crease between the screen and the plastic casing and press down.

1024

Step 2

  • After inserting the plastic opening tool, run it around the device a few times to loosen the external cover.

After inserting the plastic opening tool, run it around the device a few times to loosen the external cover.

Step 3

  • Once you’ve gone around a few times a corner will pop up, insert the opening tool there and repeat step 2 with slightly more pressure. Do this until every section of the backing has popped up.
  • Then just remove the backing.

Once you’ve gone around a few times a corner will pop up, insert the opening tool there and repeat step 2 with slightly more pressure. Do this until every section of the backing has popped up.

Then just remove the backing.

Step 4

              Front/Rear Facing Camera
  • The front/rear facing cameras are located in the corner of the device one is facing toward you and is black. The other is facing away so you will see the white backing.

The front/rear facing cameras are located in the corner of the device one is facing toward you and is black. The other is facing away so you will see the white backing.

Step 5

  • Use the plastic opening tool to pop up the cameras from their slot in the Tablet.
  • Then use your hand to lift up the cameras.
  • Make sure not to tear the ribbon cables.

Use the plastic opening tool to pop up the cameras from their slot in the Tablet.

Then use your hand to lift up the cameras.

Make sure not to tear the ribbon cables.

Step 6

  • Use a smaller plastic opening tool to lift up the ZIF connector in which the cameras are plugged into.

Use a smaller plastic opening tool to lift up the ZIF connector in which the cameras are plugged into.

Step 7

  • Finally remove the cameras.

Finally remove the cameras.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    David DeMeritt

Member since: 03/08/2016

637 Reputation

                                      6 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       UMass Dartmouth, Team 5-6, Landers Spring 2016                        

                                                  Member of UMass Dartmouth, Team 5-6, Landers Spring 2016 



                    UMASSD-LANDERS-S16S5G6                     


                                            3 Members                     


                                            6 Guides authored