Digital2 D2 861G Camera Replacement Repair Guide

Difficulty

Very easy

Steps

Time Required

                          5 - 15 minutes

Sections

Camera
5 steps

Flags

BackDigital2 D2-861G
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Camera

Working on your device while powered on may result in electric shock. Make sure to unplug and power down your device before you begin.
Place your device on a soft cloth to avoid scratching the screen
Flip your device over so back panel is facing upwards.

Working on your device while powered on may result in electric shock. Make sure to unplug and power down your device before you begin.

Place your device on a soft cloth to avoid scratching the screen

Flip your device over so back panel is facing upwards.

1024

Step 2

Do not use a lot of force as it can break the clips or the back panel.
Insert spudger in the slot below the micro SD card.
You should hear clips releasing as you pry along the edges.
With the spudger tool, run along the edges of the backing undoing 20 plastic clips.

Do not use a lot of force as it can break the clips or the back panel.

Insert spudger in the slot below the micro SD card.

You should hear clips releasing as you pry along the edges.

With the spudger tool, run along the edges of the backing undoing 20 plastic clips.

Step 3

Disconnecting the bundled cable connector helps avoid short circuiting anything on the device.
Locate the bundled cable connector and disconnect it by simply pulling it gently or using a spudger.

Disconnecting the bundled cable connector helps avoid short circuiting anything on the device.

Locate the bundled cable connector and disconnect it by simply pulling it gently or using a spudger.

Step 4

Locate and unplug the flat-top connector from the motherboard..
To unplug the connector go under it with either side of the spudger and lift up.

Locate and unplug the flat-top connector from the motherboard..

To unplug the connector go under it with either side of the spudger and lift up.

Step 5

Avoid pulling the gold connector as it can be damaged and/or broken.
To remove the camera, simply use the pointed end of the spudger and insert it in the corner and gently lift.

Avoid pulling the gold connector as it can be damaged and/or broken.

To remove the camera, simply use the pointed end of the spudger and insert it in the corner and gently lift.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 2 other contributors

                    Eduardo Duran

Member since: 09/29/2016

600 Reputation

                                      5 Guides authored                  



                       Badges:
                       12







                                                        +9 more badges

Team

                       Eastern Washington University, Team 1-3, Crane Fall 2016                        

                                                  Member of Eastern Washington University, Team 1-3, Crane Fall 2016 



                    EWU-CRANE-F16S1G3                     


                                            3 Members                     


                                            6 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team