Digital2 D2 861G Battery Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          5 - 10 minutes

Sections

Battery
4 steps

Flags

BackDigital2 D2-861G
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

Battery information:

JZ Li-ion PL28106110

3.7V 3100MAH 1406

What you need

Step 1

              Battery

Working on your device while powered on may result in electric shock. Make sure to unplug and power down your device before you begin.
Place your device on a soft cloth to avoid scratching the screen.
Flip your device over so back panel is facing upwards

Working on your device while powered on may result in electric shock. Make sure to unplug and power down your device before you begin.

Place your device on a soft cloth to avoid scratching the screen.

Flip your device over so back panel is facing upwards

1024

Step 2

Do not use a lot of force as it can break the clips or the back panel.
Insert spudger in the slot below the micro SD card
You should hear clips releasing as you pry along the edges.
With the spudger tool, run along the edges of the backing undoing 20 plastic clips.

Do not use a lot of force as it can break the clips or the back panel.

Insert spudger in the slot below the micro SD card

You should hear clips releasing as you pry along the edges.

With the spudger tool, run along the edges of the backing undoing 20 plastic clips.

Step 3

Look at the images to locate the black tabs.
Carefully remove the tape to avoid damaging the device.
Remove ALL the yellow tape securing the gold colored ZIF (Zero insertion force) connector and the battery. Discard or save the tape if you would like.
To unclip the connector. Go under the black tab with a spudger or finger nail and simply lift up.

Look at the images to locate the black tabs.

Carefully remove the tape to avoid damaging the device.

Remove ALL the yellow tape securing the gold colored ZIF (Zero insertion force) connector and the battery. Discard or save the tape if you would like.

To unclip the connector. Go under the black tab with a spudger or finger nail and simply lift up.

Step 4

Make sure to not bend or puncture the battery when removing it.
Locate the bundled cable connector and disconnect it by simply pulling it gently with your hands or using a spudger.
Use prying tools to carefully break the adhesive under the battery

Make sure to not bend or puncture the battery when removing it.

Locate the bundled cable connector and disconnect it by simply pulling it gently with your hands or using a spudger.

Use prying tools to carefully break the adhesive under the battery

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors

                    Dalton Berg

Member since: 09/29/2016

201 Reputation

                                      1 Guide authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       Eastern Washington University, Team 1-3, Crane Fall 2016                        

                                                  Member of Eastern Washington University, Team 1-3, Crane Fall 2016 



                    EWU-CRANE-F16S1G3                     


                                            3 Members                     


                                            6 Guides authored

rsdii - Mar 20, 2017

where do you find the replacement battery?

Introduction#

What you need#

#

#

#

#

#

#

Team#

#

Introduction

What you need

Team