Difficulty
Difficult
Steps
5
Time Required
1 hour
Sections
1
- Power and Volume Button Assembly
- 5 steps
Flags
Needs More Images
A few more images would make this guide’s procedures crystal clear.
BackDigiLand DL801W
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
Note: Light soldering is required for successful repair of the power button components of the DigiLand Dl801W.
What you need
Step 1
Power and Volume Button Assembly
- Before opening your DigiLand Tablet, ensure that the MicroSD card is removed.
- Hold the tablet in one hand (not your primary hand) so that the bottom edge of the tablet is facing you and the back of the tablet is facing up.
- Using a blue plastic opening tool, gently insert the tool between the back panel and the main body.
- Going around the edge of the tablet, gently pry open the back panel. As you go around, you will hear a click.
Before opening your DigiLand Tablet, ensure that the MicroSD card is removed.
Hold the tablet in one hand (not your primary hand) so that the bottom edge of the tablet is facing you and the back of the tablet is facing up.
Using a blue plastic opening tool, gently insert the tool between the back panel and the main body.
Going around the edge of the tablet, gently pry open the back panel. As you go around, you will hear a click.
1024
Step 2
- Remove the 10 JIS #000 screws from the back of the device.
Remove the 10 JIS #000 screws from the back of the device.
Step 3
- Using a spudger, lift the flaps securing the four ZIF connectors.
- The smaller of the four flaps may require you to use the point end of the spudger.
- Use the pointed end of the spudger to disconnect the ribbon cables from their ZIF connectors.
- Be careful not to damage any of the wires. If damaged, the tablet may not work correctly after repairing.
Using a spudger, lift the flaps securing the four ZIF connectors.
The smaller of the four flaps may require you to use the point end of the spudger.
Use the pointed end of the spudger to disconnect the ribbon cables from their ZIF connectors.
Be careful not to damage any of the wires. If damaged, the tablet may not work correctly after repairing.
Step 4
- After removing all of the screws and disconnect any wires, use the blue plastic opening tool and starting from the bottom near the battery, carefully lift the back metal plate and motherboard out. Set aside in a secure place.
After removing all of the screws and disconnect any wires, use the blue plastic opening tool and starting from the bottom near the battery, carefully lift the back metal plate and motherboard out. Set aside in a secure place.
Step 5
- Disconnect battery terminal using the black spudger.
- Once the battery is disconnected, the motherboard should lift right off of the metal back plate.
- Now you will be able to remove the Power Button and Volume Assembly with a soldering iron.
Disconnect battery terminal using the black spudger.
Once the battery is disconnected, the motherboard should lift right off of the metal back plate.
Now you will be able to remove the Power Button and Volume Assembly with a soldering iron.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Travis Mangum
Member since: 09/17/2015
572 Reputation
4 Guides authored
Badges:
12
+9 more badges
Team
IUPUI, Team 3-4, Harley Fall 2015
Member of IUPUI, Team 3-4, Harley Fall 2015
IUPUI-HARLEY-F15S3G4
4 Members
10 Guides authored
