Difficulty

Moderate

Steps

7

Time Required

                          10 - 15 minutes

Sections

1

  • Motherboard
  • 7 steps

Flags

3

Needs Better Images

Better photos will improve this guide. Help out by taking, editing, or uploading new ones!

Slice and Dice

The steps in this guide should be split up and made into a series of prerequisite guides.

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackDigiLand DL8006

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Motherboard
  • Remove the backing of the tablet to reveal the internal components using a plastic opening tool.

Remove the backing of the tablet to reveal the internal components using a plastic opening tool.

1024

Step 2

  • Peel back the metallic tape connecting the motherboard to the tablet body with your fingers.

Peel back the metallic tape connecting the motherboard to the tablet body with your fingers.

Step 3

  • Remove the battery plug from the motherboard.
  • Fingers may be used to gently wiggle the connector out if it becomes stuck.
  • If battery wires are under the ribbon, Do Step #4 first.

Remove the battery plug from the motherboard.

Fingers may be used to gently wiggle the connector out if it becomes stuck.

If battery wires are under the ribbon, Do Step #4 first.

Step 4

  • Opening the locking tab of the ZIF connector and carefully remove the upper section of the ribbon cable from the motherboard using tweezers.

Opening the locking tab of the ZIF connector and carefully remove the upper section of the ribbon cable from the motherboard using tweezers.

Step 5

  • Disconnect the three remaining ribbons by opening the locking tabs of the ZIF connectors and gently pulling the cables out.
  • Use tweezers to manipulate the connectors and ribbons to prevent damage.

Disconnect the three remaining ribbons by opening the locking tabs of the ZIF connectors and gently pulling the cables out.

Use tweezers to manipulate the connectors and ribbons to prevent damage.

Step 6

  • Remove the 3 mounting screws from the motherboard with a Phillips #0 screwdriver.
  • One of the screws is located under a ribbon. You will need to gently peel back the cable to access it (see image 3).

Remove the 3 mounting screws from the motherboard with a Phillips #0 screwdriver.

One of the screws is located under a ribbon. You will need to gently peel back the cable to access it (see image 3).

Step 7

  • Gently remove the motherboard from the case.

Gently remove the motherboard from the case.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 4 other contributors 


                    Alec Trela

Member since: 10/30/2019

327 Reputation

                                      2 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       University of Memphis, Team S2-G5, Kim Fall 2019                        

                                                  Member of University of Memphis, Team S2-G5, Kim Fall 2019 



                    UM-KIM-F19S2G5                     


                                            3 Members                     


                                            5 Guides authored